User manual ELECTRO-VOICE TG-7

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficent magnitude to constitute a risk of electric shock to persons. install in accordance with the manufacture's instructions. Do not install near heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or the grounding-type plug. [. . . ] CONFIG/SERVICE/Firmware Version: This menu item shows version and date of the firmware that is actually installed in the power amplifier. The MODULE CONFIG menu provides access to RCM-26 remote control module settings, which are available from the LC display of the power amplifier. This menu cannot be accessed during operation of the power amplifier. Accessing this menu is only possible when the power amp is switched off. the following steps open the MODULE CONFIG menu: 1. If the power amplifier is powered on or in standby mode, use the mains switch on the front panel to switch the power amp off. Use the power switch on the front panel to switch the power amplifier on. 5 shows the structure of the MODULE CONFIG menu of a TOUR GRADE SERIES amplifier with a installed RCM-26 remote control module. 5: Structure of the Module Config menu (RCM-26) The following provides detailed information about the individual items of the MODULE CONFIG menu. mODULE CONFIG/Preset: The name of the currently active preset is displayed. Pressing the ENTER button opens the Load Preset dialog box, which allows the user to select a preset by pressing the Up/Down buttons. Pressing the ENTER button opens a safety dialog box, which lets the user select whether he actually wants to load the selected preset by pressing the Up/Down buttons to either select YES or NO. when YES has been selected , pressing the ENTER button loads the selected preset and the display returns to the MODULE CONFIG menu. When NO has been selected, the selected preset is not loaded. The power amp's currently active preset is not changed and the MODULE CONFIG menu reappears on the display. CAUTION: The selected preset must be suitable for the use with the connected loudspeaker components. An incorrectly adjusted preset or incompatible preset can cause serious damage to the connected speaker systems. Pressing the ENTER button opens the Set CAN-Baudrate dialog box, which by pressing the Up/Down buttons, lets the user select one of the following CAN baud rates: 10kBaud, 20kBaud, 62. Pressing the ENTER button opens the Select Audio-Input dialog box, which, by pressing the Up/ Down buttons, allows selecting Analog or AES/EBU inputs. MODULE CONFIG/Power: The power amp's actual operating status after using the mains switch is displayed. If standby mode has been activated via IRIS-NetTM and the power amplifier has been switched off using the mains switch, the power amp automatically restarts into standby mode the next time it is switched on by pressing the mains switch. This menu item allows booting the power amplifier out of standby mode, even without IRIS-NetTM. [. . . ] Improvement of signal quality With CAN bus systems, whose bus length exceeds 1000 meters, a CAN bus repeater should be used. Creation of alternative network topologies By using one or several repeaters, not only the above-mentioned bus topology, but the creation of other network topologies are also possible. The following illustrations show examples of the data-bus wiring for different sizes of CAN-bus networks. 11: System with 5 power amps (with RCM-26) and 1 USB-CAN-Converter. [. . . ]