User manual ELECTRO-VOICE UHF WIRELESS REV D 5-2008

[. . . ] Operating Instructions UHF WIRELESS MICROPHONE SYSTEM User Guide ENGLISH Table of Contents Section 1 - Quick Set-Up . 2 Section 3 - Detailed Component Description . . 8 Handheld Transmitter Setup and Operation . . 10 Handheld Transmitter Setup and Operation . [. . . ] Press SET and DOWN again to display the gain setting screen. Press SET and DOWN again to show the RF Transmit Level. Press SET and DOWN again for Voice/Guitar. Set and Down one more time returns you to the Group and Channel screen. Frequency Edit Mode - (User Group Only) 1. With the frequency screen displayed, press SET and use UP and DOWN to adjust frequency. Press SET and DOWN at the same time four times to return to Group and Channel mode. Attach Microphone or Guitar/Instrument Microphone - plug the TA4 end of the microphone cable into the top panel of the REV-BP. Speak into the microphone and the Audio Meter bar graph should indicate audio signal presence. Guitar - Press SET-DOWN until voice is displayed. Press SET, display will flash, press UP and display will change to Guitar, press set and return to main display. NOTE: The REV receiver must also be put into Instrument mode to optimize the system for guitar. Strum the guitar and the Audio Meter bar graph on the receiver should indicate audio signal presence. With the Gain Setting displayed, press SET and the level numbers will flash. Use UP and DOWN to adjust the transmitter gain. Watch the Audio meter on the receiver and set the gain to peak between 50 and 100 when singing/speaking into the microphone as loud as it will be used during the performance. Press SET and DOWN at the same time two times to return to Group and Channel mode. NOTE: Operating with the transmitter audio gain set as high as possible (without distortion or peaks all the way to the right end of the meter) will result in the best performance and highest signal to noise ratio. With the RF Transmit Level displayed, press SET and the Level (on the right) will flash. Use UP and DOWN to set it at Hi (50mW) or Lo (5mW). Press SET and DOWN at the same time once to return to the Group and Channel mode. Power Lock Out - Disables the power switch 1. [. . . ] ElectroVoice/Telex strongly urges the user to contact the appropriate licensing authority for any desired clarification. Modifications: The user is cautioned that any unauthorized modifications to the equipment may void the users authority to operate the equipment. DECLARATION OF CONFORMITY Telex Communications, Inc. Declares, under our sole responsibility, that the following products: Model: REV-D REV-S REV-PH REV-H REV-WT REV-BP Certified to: ETSI EN 300 422-2 v1. 1. 1 ETSI EN 301 489-9 v1. 3. 1 Description Dual Receiver Single Receiver Handheld Transmitter Handheld Transmitter Beltpack Transmitter Beltpack Transmitter Is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Further guidance or information can be obtained by contacting: Telex Communications, Inc. [. . . ]