User manual ELECTRO-VOICE XI-2153A64F EDS

[. . . ] Xi-2153A/64F Dual 15-Inch Three-Way, Full-Range 60° x 40° Sound Reinforcement System Key Features: · · · · · · · · · · High-Level, Three-Way Design VBS Ready to Provide Very Directional Vertical Coverage Dual EVX155 15" Slot-Loaded Low-Frequency Drivers DL12ST 12" Mid-Bass Driver Coaxially-Mounted ND6-16 3" Diaphragm HF Compression Driver Rotatable HF Section for Vertical or Horizontal Suspension Ring-Mode Decoupling / RMDTM Built-In L-Track Rigging Available in Black and White Footprint Identical to Xi-1153A, Xi-1183A, Xi-1191A, Xi-2181A, Xi-2122MHA and Xi-1122MHA General Description: The Electro-Voice Xi-2153A/64F is a full-bandwidth, threeway, triamp system designed for medium- to long-throw applications. [. . . ] The ND6-16 highfrequency driver/horn combination is fully "shrouded" to preserve midbass wave-front detail, while allowing a compact coaxial configuration. ® Technical Specifications: Freq. Range1 (-10 dB): 46 Hz - 19 kHz Max Calculated SPL2: 136 dB Coverage: 60° x 40° (Rotatable) LF Power Handling: 1200W Continuous, 4800W Peak MB Power Handling: 300W Continuous, 1200W Peak HF Power Handling: 75W Continuous, 300W Peak LF Sensitivity: 100 dB, 1W/1m MB Sensitivity: 107 dB, 1W/1m HF Sensitivity: 112 dB, 1W/1m LF Impedance: 4 ohms (Nominal) MB Impedance: 8 ohms (Nominal) HF Impedance: 16 ohms (Nominal) LF Transducer: (2) EVX155 15" (381mm) Drivers, 8 ohms MB Transducer: DL12ST 12" (305mm) Driver, 8 ohms HF Transducer: ND6-16 3" (76mm) Diaphragm Comp. Driver, 16 ohms Crossover Frequency3: Use Recommended Parameters Connectors: Two Neutrik Speakon® NL8MPR Paralleled Enclosure Material: 13-ply Birch plywood Grille: 16 GA steel Dim (H x W x D): 1233 x 586 x 759 mm (48. 5" x 23. 1" x 29. 9") Net Weight: 109 kg (240 lbs) Shipping Weight: 113 kg (249 lbs) 1 2 3 Full Space measurement with a Dx38 Controller Max Calculated SPL of MB Section Download at www. electrovoice. com Xi-2153A/64F Full Range Loudspeaker (3-Way) Frequency Response (Full & Half Space): Impedance: Beamwidth (3-Way): Horizontal Off Axis Frequency Response: Beamwidth with VBS (Tripole): Vertical Off Axis Frequency Response (Up): Directivity (3-Way): Vertical Off Axis Frequency Response (Down): Directivity with VBS (Tripole): Engineering Data Sheet Horizontal 1/3 Octave Polars: Vertical 1/3 Octave Polars, without VBS: with VBS: Dimension Drawings: Wiring/Connection Chart: Triamp LF: Pins 1 In Pins 2 Out MB: Pins 3 In Pins 3 Out HF: Pins 4 In Pins 4 Out Pins 2 In Connected to Pins 1 Out CAUTION This Xi Loudspeaker should be suspended overhead only in accordance with the procedures and limitations specified in the X-Array Xi Install Flying Manual and possible manual update notices. This system should be suspended with certified rigging hardware by an authorized rigging professional and in compliance with local, state, and federal overhead suspension ordinances. Performance Match Xi-2153A/64F Part Numbers · · 1058-3418 - Black 1058-3411 - White Architectural & Engineering Specs: · P3000 (RL) · CPS 2. 8 · Dx38 · P1200 (RL) · CPS 2. 11 The loudspeaker system shall be a three-way tri-amp system. The system shall have two (2) 15-inch, low-frequency loudspeakers with a nominal impedance of 4 ohms and a 4 inch aluminum voice coil. The low-frequency loudspeakers shall have a power handling capacity of 1200 watts with a shaped pinknoise signal with a 6-dB crest factor for 8 hours (as per ANSI/EIA RS-426 A & AES 2-1984) The mid-bass loudspeaker shall be a fully horn loaded, 12-inch driver with a 2. 5-inch voice coil and a nominal impedance of 8 ohms. The mid-bass driver shall have a power-handling capacity of 300 watts for 8 hours (as per ANSI/EIA RS-426 A& AES 2-1984). The highfrequency section shall be coaxially mounted in the mid-bass horn and shall employ a compression driver capable of handling 75 watts, 1, 760- to 20, 000-Hz when pink noise of a 6-dB crest factor is applied for 2 hours (as per AES 2-1984 and ANSI S4. 26-1984 standards). [. . . ] For customer orders, contact Customer Service at: + 1 952 884-4051 Fax: + 1 952 736-4212 For warranty repair or service information, contact the Service Repair department at: 800/685-2606 For technical assistance, contact Technical Support at: 866/78AUDIO Specifications subject to change without notice. 12000 Portland Avenue South, Burnsville, MN 55337 Phone: 952/884-4051, Fax: 952/884-0043 www. electrovoice. com © Telex Communications, Inc. [. . . ]