User manual ELECTROLUX EFL90563OX

[. . . ] We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available. The information can be found on the rating plate. Closely follow the instructions set out in this manual. [. . . ] Filter - The saturation of the charcoal filter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace the cartridge at least every four mounths. The charcoal filter may NOT be washed or regenerated. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. 1 Grease filter - The grease filter must be cleaned once a month using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. The control switches are located on the unit's front panel: 1 Suction speed (power) ON-OFF/ decrease key Suction speeds (powers) 3 and 4 have a limited duration, respectively 10 and 5 minutes, after which suction speed (power) 2 is activated. Note: The LED on the display flashes indicating speed timing. 4 "Breeze" function key (Environment ventilation) The hood switches on at low suction speed (power) for about one hour and then switches off. 5 Display Filter saturation indicator At regular intervals, the hood warns when the filters must be serviced. Grease filter saturation indicator The set speed and the letter "F" alternate on the display. Carbon filter saturation indicator The set speed and the letter "C" alternate on the display. Reset of saturation indicator In order to reset the saturation indicator, switch on the hood then press and hold button 1 for about 3 seconds. [. . . ] Sørg for at have følgende data tilgængelig, når du kontakter service. Manglende overholdelse af kravene for rengøring af emhætten, og for udskiftning og rengøring af filtrene, medfører brandfare. Hvis emhætten ikke er udstyret med et stik (direkte tilslutning til elnettet), eller hvis stikket ikke findes i et område, der også er let tilgængeligt efter installeringen, skal der monteres en topolet afbryderkontakt i overensstemmelse med standarderne, der sørger for fuld afbrydelse fra elnettet i tilfælde af forhold i overspændingskategori III, og i overensstemmelse med reglerne for elektriske installationer. NB: Led'en på displayet blinker for at angive tidsindstillingen for hastigheden. [. . . ]