User manual ELECTROLUX EHH3320NVK

[. . . ] You’ve chosen a product that brings with it decades of professional experience and innovation. ingenious and stylish , it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. [. . . ] You do not deactivate a cooking zone or change the heat setting. After some time comes on and the hob deactivates. The relation between the heat setting and the time after which the hob deactivates: Heat setting , 1-2 3-4 5 6-9 The hob deacti‐ vates after 6 hours 5 hours 4 hours 1. 1 Activating and deactivating Touch for 1 second to activate or deactivate the hob. 2 Automatic Switch Off The function deactivates the hob automatically if: • • • all cooking zones are deactivated, you do not set the heat setting after you activate the hob, you spill something or put something on the control panel for more than 10 seconds (a pan, a cloth, etc. An acoustic signal sounds and the hob deactivates. Remove the object or clean the control panel. Let the cooking zone cool down before you use the hob again. 3 The heat setting Touch Touch to increase the heat setting. ENGLISH 27 Touch and at the same time to deactivate the cooking zone. 4 Automatic Heat Up If you activate this function you can get a necessary heat setting in a shorter time. The function sets the highest heat setting for some time and then decreases to the correct heat setting. To activate the function the cooking zone must be cold. To activate the function for a cooking zone: touch ( comes on). Immediately touch To set the cooking zone: touch again and again until the indicator of a necessary cooking zone comes on. To activate the function or change the time: touch or of the timer to set the time (00 - 99 minutes). When the indicator of the cooking zone starts to flash slowly the time counts down. To see the remaining time: set the cooking zone with . The indicator of the cooking zone starts to flash quickly. To deactivate the function: set the cooking zone with and touch . The indicator of the cooking zone goes out. When the time comes to an end, the sound operates and 00 flashes. [. . . ] 2 Built-in hobs Only use the built-in hobs after you assemble the hob into correct built-in units and work surfaces that align to the standards. Com the seal stripe are located in the middle of one side of the hob. Add some mm when you cut the seal stripe to the length. Push the two ends of seal stripe together. [. . . ]