User manual ELEKTRO HELIOS DC400

[. . . ] 8 Switching off water softening system . 9 Switching off rinse aid refill indicator . 16 Express Wash/ Speed Perfect (VarioSpeed) . 16 en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. [. . . ] This function can be changed as follows: – Open the door. – Hold down programme button # and press START button )" until : . . . . The LED for button # flashes and the digital display 8 displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display 8. To change the setting, – Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). – Press START button )", the set value is saved. – Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 8. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 17 en Automatic switch off after end of programme or interior light* gitlho/iterntfAom hcsua iw Switching off the appliance Short time after the end of the programme: – Open the door. – Turn off the tap (not applicable if AquaStop fitted). – Remove the utensils when they have cooled down. * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The only way a programme can be changed is by Cancel programme (Reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) – Open the door. – Hold down programme button # and press START button )" until : . . . . The LED for button # flashes and the digital display 8 displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display 8. To change the setting, – Press the button 3 to switch the or off : . Intensive drying on : – Press START button )". – Close the door. Overall condition of the machine – Check spray arm for grease and limescale deposits. If you find such deposits: – Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. [. . . ] See rating plate for required fusing 92. – The socket must be near the appliance and freely accessible following installation. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. – The connection may be modified by technicians only. [. . . ]