User manual ELNA 5200

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. When using an electrical appliance, basic safety precautions should always be followed, including the following: Your 5200 sewing machine is designed and manufactured for household use only. Read all instructions before using this sewing machine. Always unplug this sewing machine from the the risk of shock: 1. [. . . ] Sew first row next to raw edge using foot A as guide. Sew second row next to first row using foot A as guide. Leave long thread tails at beginning and end of each row. Pull on the bobbin threads simultaneously from each end of the fabric until the desired amount is gathered. OR Lay gather fabric over flat fabric and sew the two fabrics together directly on the second row of gathering stitches. When sewing with the zipper foot, make sure to use pattern 01 (straight stitch with the center needle position). Otherwise the needle may hit the foot and possibly break. Lapped Application Lapped zippers are usually inserted into a side seam of skirts or pants, for example. W q Use zipper foot E instead of standard metal foot A. To sew the left side of the zipper, attach the zipper foot on the right-hand side. Use this measurement and mark the opening for the zipper. Place right sides of fabric together and sew the seam located below zipper placement. (Make sure to reverse sew the stitches directly below the zipper placement. Teeth are on the seam line and zipper top is 1 cm (3/8) from fabric top edge. Turn zipper face up (right seam allowance forms a small fold at basting line) and smooth zipper teeth away from seam. Starting at the bottom, sew through the folded seam allowance and zipper tape. Stop just before the zipper foot reaches the slider on the zipper tape. Lower the needle slightly into the fabric. Raise the zipper foot and open the zipper. Lower the foot and stitch the remainder of the seam. Close the zipper and spread the fabric flat with the right side facing up. Baste through the opened seam allowance and zipper tape. [. . . ] If a buzzer sounds and the indicator shows a warning sign, follow the guidance below. Cause The power is turned on with the foot control not being connected. The foot control is disconnected while sewing. The machine is re-started too soon after it has halted due to the overload. [. . . ]