User manual EMERSON FANS 36 NORTHWIND

[. . . ] READ AND SAVE THESE INSTRUCTIONS 42" Model No. CF704W02 CF704WPB02 CF704PB02 CF704WW02 CF704AB02 CF704AW02 Net Weight: 11. 1 Lbs. 36" Model No. 29" Model No. CF703WW02 CF702WW03 CF703PB02 CF702PB03 Net Weight: 11. 1 Lbs. Net Weight: 10. 5 Lbs. by ® Ceiling Fan Owner's Manual LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for twenty years from the date you purchased your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. [. . . ] Position the switch housing assembly on the switch housing plate and align the holes in the switch housing assembly with the holes in the plate. Secure the switch housing assembly by installing the three screws (Figure 2). ! SWITCH HOUSING ASSEMBLY WARNING MOUNTING SCREWS (3) To avoid possible fire or shock, do not pinch wires between the switch cup assembly and the switch Figure 2 SWITCH HOUSING PLATE 3. Pass the 80" motor leads through the opening in the ceiling cover. Be sure the cover is oriented correctly. Separate, untwist and unkink the three motor leads. Route the motor leads through the hanger ball/downrod assembly. Remove the upper setscrew from the motor coupling. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 3). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the hanger ball to make sure the clevis pin is properly installed. ! HANGER BALL/ DOWNROD ASSEMBLY CEILING COVER CLEVIS PIN CLEVIS PIN HAIRPIN CLIP 3/16-24 x 1/2" SCREW WITH JAM NUT MOTOR COUPLING Figure 3 WARNING (3) 3/16-24 x 5/16" SLOTTED PHILLIPS WASHER HEAD BLADE SCREWS It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling. BLADE FLANGE 6. Install the 3/16-24 x 1/2' screw with jam nut (supplied) in the motor coupling (Figure 3). While pulling up on the hanger ball, securely tighten the setscrew. Then securely tighten the nut against the motor coupling. NOTE: The setscrew must be properly installed as described above, or fan wobble could result. The fan comes with blue, black and white leads that are 80" long. Before installing fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads. Turn fan assembly upside down in preparation for mounting fan blade assemblies. [. . . ] Check to make sure that the switch housing does not bind against the blade hub. Check to make sure wire connectors in switch against the interior wall of the switch housing. Tighten the setscrew and then tighten the jam nut. Tighten the setscrew in the hanger ball/downrod assembly. [. . . ]