User manual EMERSON FANS BUCKINGHAM

[. . . ] READ AND SAVE THESE INSTRUCTIONS ® BUCKINGHAMTM Ceiling Fan Owner's Manual Net Weight: Model No. 15. 5 Lbs. CF715AW00 CF715PW00 CF715AB00 CF715WB00 CF715S00 LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for twenty years from the date you purchased your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. [. . . ] Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed. ! 5. Reinstall the hanger ball (Figure 3) on the downrod as follows. Route the three 80" motor leads through the hanger ball. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble. ! WARNING It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling. WARNING It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 2) could result in the fan falling. 6. The fan comes with blue, black and white leads that are 80-inches long. Before installing the fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads. Mount blade flanges to fan blades using three 3/16-24 x 5/16" slotted Phillips head screws and three blade washers (Figure 4). ! WARNING MOTOR COUPLING SETSCREW HAIRPIN CLIP CLEVIS PIN To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades. DOWNROD 3/16-24 x 5/16" SLOTTED PHILLIPS HEAD SCREW (3) BLADE WASHER (3) CLEVIS PIN HAIRPIN CLIP MOTOR COUPLING SETSCREW FAN BLADE Figure 2 BLADE FLANGE 3. Make sure the connector latch closes properly. WARNING SWITCH HOUSING ASSEMBLY To avoid fire or shock, follow all wiring instructions carefully. Any electrical work not described in these instructions should be done or approved by a licensed electrician. SWITCH HOUSING CONNECTOR LATCH MOTOR CONNECTOR How to Hang Your Ceiling Fan ! WARNING Figure 6 MOUNTING SCREW The fan must be hung with at least 7' of clearance from floor to blades (Figure 8). CEILING 12. Remove the three mounting screws from the switch housing plate (Figure 6). Position the switch housing assembly on the switch housing plate and secure using the three mounting screws (Figure 7). NOTE: Do not pinch wires between the switch housing assembly and the switch housing plate. You have now completed the assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan. [. . . ] Some fan motors are sensitive to signals from Solid-State variable speed controls. If Solid-State Control is used and motor noise results choose an alternative control method. Tighten the setscrew in the motor coupling securely. Tighten the setscrew in the hanger ball/downrod assembly. [. . . ]