User manual EMERSON HD7002-1

[. . . ] CAUTION: Read all instructions carefully before installation. Save this Owner's Manual for future reference. Model Nos. HD7002 1 & HD7005 0 EMERSON MoistAIRTM HD7002 & HD7005 Evaporative Console Humidifier Owner's Manual Part No. SP6470 ® Printed in Canada Limited Warranty All products covered by this Owner's Manual are warranted against defects in workmanship and materials for one year from the date of sale except for motors, which are warranted for two years. [. . . ] For proper operation, the "E-Z-Fill Side-Cap" must be facing the center of the cabinet. When positioned properly, the plunger will open and water will flow into the cabinet. The water level will automatically remain at approximately 1" until the bottle is empty. The unit is now ready for operation. Turn Counterclockwise to Remove "E-Z-Fill Side-Cap Valve Cap Plunger 6 Operating Humidifier Controls The operating controls of your Emerson evaporative humidifier are located on the top right of the humidifier. The controls are found under the smoked cover Lift the control cover by placing your finger in the round cutout and lifting. Now you can clearly see the control area. Familiarize yourself with the controls and their functions as described below. Fill Light When the unit has a small amount of water left in it, the fill light will come on and the unit will automatically shut off. Humidity Control: Adjust the amount of humidity depending on your needs. The humidifier will turn on and off as required to maintain level of humidity selected. A medium setting (midway between and ) is recommended, but there are times when a low or high amount of humidity may be preferred. For constant operation of humidifier, rotating knob all the way clockwise allows for the maximum amount of humidity to be evaporated into the air continuously. IMPORTANT: Water damage may result if condensation starts to form on windows or walls. Humidity Control setting should be lowered until condensation no longer forms. Air Flow (Speed) Control The unit is adjusted from OFF " " to high " " with a three speed rotary control. The higher the air flow speed, the more water is evaporated and released into the air. Low speed " " is the quietest and is provided for conditions that may not require as high an evaporation rate. 7 Using Your Humidifier 1. Be sure unit is full of water and plugged in. If humidifier stops running and the Fill Light is not illuminated, the humidity level is at the normal requirements for that setting or it is adjusting to the home conditions. The table below shows relative humidity percentages which are recommended at various outdoor temperatures. The figure below shows approximate relative humidity percentages which correspond to the various settings of the Humidity Control When Outdoor Recommended Indoor Temperature is: Relative Humidity is: -10°F 0°F 10°F 20°F & above Rel. Set Humidity Control position (halfway between NOTE: Humidifier should operate with humidity control on the recommended medium setting (midway between and ). If it does not, the humidity is at a relatively high level. To test the unit under this condition, turn Humidity Control all the way to clockwise and unit should begin to operate. After the unit has been tested, set Humidity Control to medium or desired level. Allow 24 hours for humidifier to adjust. [. . . ] Install new filters in clean humidifier before next season begins. "Bi-Weekly Maintenance" is also recommended if you do not plan to run the humidifier for one week or more. CAUTION: Use liquid EPA-approved bacteriostat available from your local retail store. Use of other water treatment products may damage the filter elements. Under no circumstances should you use water treatment products designed for Roto belt or Ultrasonic humidifiers. 12 Troubleshooting TROUBLE PROBABLE CAUSE REMEDY · Turn speed control clockwise. [. . . ]