User manual EMOS W177-1

[. . . ] Press Functions CLOCK ALARM UP DOWN CHANNEL/SEARCH MEMORY HEAT INDEX/DEW POINT PRESSURE SNOOZE/LIGHT ZONE C/F Read time, calendar and day-of-week Read alarm time; enable/disable alarm 1 step forward in setting 1 step backward in setting Select indoor, Channel 1, 2, 3, auto scroll Read max/min temperatures & humidity Read Heat Index & Dew Point Toggle pressure unit hPa, inHg & mb Trigger snooze alarm & extend backlight Toggle RC time & Zone time Toggle degree C & F unit Search for Radio-Controlled time RESET Slide Switch BACKLIGHT AUTO HIGH LOW OFF *** AUTO mode is recommended to adjust the brightness automatically automatic Display brightness setting Zone time setting Altitude setting Hold 3 seconds Set Clock & Calendar Alarm time setting Fast advance Fast backward Search for remote sensor Clear memory record Heat Index combines the effects of heat and humidity. It is the apparent temperature of how hot the heat-humidity combination makes it feels. Press "Heat Index/Dew Point" button once to show the respective indoor or outdoor heat index on the upper left display. Please disposal of old, defective batteries in an environmentally friendly manner in accordance with the relevant legislation. [. . . ] The higher the temperature & humidity, the more color portion of the color graph appears. Lower temperature & humidity show less color portion of the color graph. Maximum / minimum memory Press MEMORY button repeatedly to view the maximum & minimum values of temperature, humidity, heat index or dew point readings. To clear the memory record, hold MEMORY button while the respective values are displaying on screen. For the first installation, always turn on the home unit and then the remote sensor. Press and hold CHANNEL/SEARCH button on main unit until a beep is sound to search for remote sensor. The unit will start synchronizing the clock after battery/adapter installation or reset. in normal mode , press in the battery compartment to enforce searching of radio-controlled clock signal. The antenna icon will appear during synchronization, if the icon disappear afterwards, radio time signal is not available at the moment. Place the unit away from source of interference such as mobile phones, appliances, TV etc. Antenna icon with full signal strength will appear on screen if the reception of radio-controlled time is successful. The icons will indicate Rising, Steady, Falling if the temperature or humidity change is more than 1 degree C (or 2 degree F) within an hour. Press "CLOCK" to toggle display between time, calendar and day of the week. hold "CLOCK " button to enter clock setting mode. Using or to adjust and "CLOCK" to confirm, the following values can be set in sequence: 12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > EXIT Home time, world (zone) time hold "ZONE" to enter world (zone) time setting mode. Press or to enter the desired hour offset value from ­12 to +12 hours. press "ZONE" to confirm each setting. Press "ZONE" button to toggle between home (radio-controlled) time and world (zone) time. "ZONE" icon appears when world (zone) time is selected. When zone time is not used, set zone time to "0". [. . . ] AUTO Display brightness is adjusted automatically according to the surrounding brightness detected by the light sensor located on the left of the Snooze/Light button. Auto mode is recommended for power saving, display lifetime and convenient purpose High Turn to high brightness mode Low Turn to low brightness mode Off Turn off display backlight Important: Avoid having obstacle above the light sensor window for an accurate light sensing result. Otherwise the display will turn dim even in bright environment. Temperature reading is located on the upper left of the display and humidity is on the right of the temperature. [. . . ]