User manual EMTEC EKCOH180

[. . . ] if this happens see a doctor immediately. Leaking or damaged batteries can upon contact with skin cause burning or acid damage - if necessary use suitable gloves Please dispose of batteries in accordance with local bylaws 8 in 1Universal Remote Control EKCOH180 Contents 1) Introduction 2) Put in the batteries 3) Functions of the key 4) Programming of the TV, VCR, DVD , SAT mode, . 5) Manual code search 6) Automatic code search 7) Brand search 8) Identifying codes found 9) Default Volume Control 10) Troubleshooting The 8 in 1 Universal Remote Control contains a library of codes that are pre-programmed into the remote control. This library covers nearly all the audio video products on the market today. [. . . ] Press and release the mode key (3) of the device you want to control (for example TV). Press first the Mode key (6) for DVBT, CBL, AMP and AUX. Enter the 4 digit code (13) from the Code Book. the LED (1) turns off after the last digit is entered. If you entered a wrong code the LED blinks for 3 seconds and then goes off. Check other functions (for example for a VCR: FF or REW etc. If certain functions are not responding this indicates that the entered code is not the correct one. In that case repeat the above procedure with the next corresponding code of your brand. Repeat this procedure from step 1 for the other equipment you want to control (TV, VCR, DVD, SAT) 5) Manual code search If your equipment (TV, SAT etc. ) does not respond, try the other codes for your brand. If it still doesn't respond, try the Code Search method. Note: As you can dedicate any appliance (TV, DVD, SAT. : If you want to program a SAT under the VCR key, enter any SAT code found in the code book and then follow the steps below: Make sure your equipment is switched on. Press and hold SETUP (4) until the LED indicator lights steadily. Press the mode key (3) that matches the equipment you want to control (for example TV). Press first the Mode key (6) for DVBT, CBL, AMP and AUX programing. If you step past the correct code use PROG - (7) to go back to the right code. Note: If your equipment doesn't have PROG +, you can use PLAY (VCR or DVD) (17) or POWER (2) key. The search starts after the last registered code. If that was 0030, the search starts at 0031 until the last possible code and then goes from 0000 to 0029. Note: if certain functions of your equipment can't be controlled you havetofindadifferentcodeforyourbrand. 6) Automatic code search When searching an unknown code, you can step through the library automatically (AutoSearch). [. . . ] Control of the television set sound in TV mode, control of the SAT receiver sound in SAT mode, . Press and hold SETUP (4) until the LED indicator (1) lights steadily. Make sure that you have pressed the corresponding mode key of the equipment or device that you want to control. â· If the listed code does not work , try the AUTOSEARCH method or enter the next code of that brand. [. . . ]