User manual ENCORE ENH908-NWY

[. . . ] ENH908-NWY 8 Port Switch User Guide 0 The ENH908-NWY is a powerful, high-performance Fast Ethernet switch, with all ports capable of 10 or 100Mbps auto-negotiation operation (NWay), which means the switch could automatically negotiate with the connected partners on the network speed and duplex mode. It is ideal for micro-segmenting large networks into smaller, connected subnets for improved performance, enabling the bandwidth demanding multimedia and imaging applications. [. . . ] Moreover, the rich diagnostic LEDs on the front-panel can provide the operating status of individual port and whole system. Before you start to install the switch, check the following contents in this package One NWay switch One external power adapter User's manual 1 Please refer to the following table for LED definition 8port Status Steady Green Off Link/Act Steady Green Blinking Green Off LED Power Operation Power is on Power is off The port is connected The port is transmitting/receiving data. No connection Rear Panel 8port 2 Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station's network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table. In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable. As all the ports support auto MDI / MDI-X function, using a straight cable to make a switch-to-switch connection is allowed. For cable selection, refer to the following table Network Speed 10Mbps 100Mbps Cable Type Cat. Length 100 meters 100 meters 3 Standard IEEE 802. 3 10BASE-T IEEE 802. 3u 100BASE-TX IEEE 802. 3x full duplex operation and flow control 8* 10/100Mbps RJ-45 Fast Ethernet Ports Auto MDI/MDI-XAuto crossover 10/100Mbps & Full/Half duplex mode auto detection 1K MAC address entries 768KBytes (8port) External Power adapter 5V DC 0. 6A CE, FCC Interface Uplink Network Speed MAC Address Table Memory Power Supply EMI 4 FCC Certifications This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] Trademarks: All trade names and trademarks are the properties of their respective companies. Copyright © 2008, All Rights Reserved. 5 [. . . ]