User manual ENCORE ENH916P-NWY

[. . . ] ENH916P-NWY 16-Port Fast Ethernet Switch User Guide FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limitations are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if no installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Please check with your local distributors for the latest information. No part of this document can be copied or reproduced in any form without written consent from the company. Trademarks: All trade names and trademarks are the properties of their respective companies. CE Declaration of conformity This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022 class A for ITE, the essential protection requirement of Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility. Unpacking Information Thank you for purchasing the 16-Port Fast Ethernet Switch. Before you start, please check all the contents of this package. The product package should include the following: 1. One 16-Port Fast Ethernet Switch One power adapter User's Manual 2 2. Introduction 2. 1 General Description The device is a powerful, high-performance Fast Ethernet switch, with all 16 ports capable of 10 or 100Mbps auto-negotiation operation (NWay), which means the switch could automatically negotiate with the connected partners on the network speed and duplex mode. It is ideal for micro-segmenting large networks into smaller, connected subnets for improved performance, enabling the bandwidth demanding multimedia and imaging applications. Moreover, the 10/100Mbps auto-sensing ability provides an easy way to migrate 10Mbps to 100Mbps networks with no pain. Compared to the shared 10Mbps or 100Mbps networks, the switch delivers a dedicated 10/100Mbps connection to every attached client with no bandwidth congestion issue. Store-and-forward switching mode promises the low latency plus eliminates all the network errors, including runt and CRC error packets. To work under full-duplex mode, transmission and reception of the frames can occur simultaneously without causing collisions as well as double the network bandwidth. The switch is plug-n-play without any software to configure and also fully compliant with all kinds of network protocols. Moreover, the rich diagnostic LEDs on the front-panel provide the operating status of individual port and whole system. [. . . ] Plug one RJ-45 connector into a rear-panel port of the switch, and plug the other RJ-45 connector into the station's network adapter. Switch to Switch Connections with Twisted-Pair Cable In making a switch to switch connection, you could use any port to connect another switch with straight or cross-over cable. As the entire ports support auto MDI-X function, so the connection is independent of cable type and using a straight cable to make a switch to switch connection is allowed. 5 4. Product Specifications IEEE802. 3, 10BASE-T IEEE802. 3u, 100BASE-TX Standard IEEE802. 3x Full Duplex operation and Flow Control Interface 16 * RJ-45 NWay switching ports RJ-45 (10BASE-T) : Cable Connections Category 3, 4, 5 UTP/STP RJ-45 (100BASE-TX) : Category 5 UTP/STP Network Data Rate Transmission Mode Auto-negotiation (10Mbps, 100Mbps) Auto-negotiation (Full-duplex, Half-duplex) System LED indications Power Port Link/Activity System Buffer Memory MAC Address Table Filtering/Forwarding Rate Emission Operating Temperature Operating Humidity Power Supply 156K Bytes 8K MAC entries 10Mbps: 14, 880pps/14, 880pps 100Mbps: 148, 800pps/148, 800pps FCC Class A, CE, VCCI 00 ~ 400C (320 ~ 1040F) 10% - 90% External (12V/1A) linear power adapter 6 [. . . ]