User manual ENCORE ENHWI-N

[. . . ] ENHWI-N ENCORE 802. 11n Wireless Router User Manual FCC Certifications Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Select the transmission priority of low, medium, high, or highest. Fill in the minimum and maximum bandwidth. Give a definition to the LAN IP Address. After configuring the above settings, click Add to add a new list in the following MAC Access Control List. The Change button can be used to change the configuration. * Please click on the Save Settings button or the Reset Settings button on the above table to save/reset the configurations. Bandwidth QoS Settings Lists the Bandwidth QoS Settings you have added before. Click on the list to change configuration, or the Delete button to delete the list. 16 Wireless Settings Basic Settings You can set up the configuration of your Wireless and monitor the Wireless Clients associate with your AP. Information Mark the checkbox to enable Wireless interface or uncheck to disable. To select a band for this device to match 802. 11g/b/n Wireless Mode mixed, 802. 11g/b mixed, 802. 11b, 802. 11g, or 802. 11n. Country Wireless Channel Select a channel for the wireless network of this device. Service set identifier for the name of the wireless SSID network. * Please click on the Save Settings button or the Reset Settings button on the above table to save/reset the configurations. Items Enable Wireless 17 Advanced Settings You can set advanced wireless LAN parameters of this router. We recommend not changing these parameters unless you know what changes will be there on this router. 18 General Wireless Advance Settings Information Mark to disable SSID from broadcasting. As default, this device broadcasts its SSID to allow every wireless station located within the coverage of this wireless router to discover this wireless router easily. The period of time a beacon is broadcasted (default Beacon Period 100ms). The beacon of a Delivery Traffic Indication Message DTIM Period is broadcasted (default 1 beacon). If the packet size is smaller than the Request To RTS Threshold Send threshold, the wireless router will not send this packet by using the RTS/CTS mechanism (default 2347 bytes). Fragment Threshold Specifies the maximum size of packet during the data transition. A higher value brings a better performance (default 2346 bytes) Select the Transmission Power of very weak, weak, Tx Power medium, and strong according to your demand. Allows the adapters search for 802. 11g/b singles g/b Protection only. Select "Auto" to turns it on or off automatically, select "Always On" to support protection or select "Always Off" to disable this function. To enable/disable Wi-Fi Multimedia function. Support WMM * Please click on the Save Settings button or the Reset Settings button on the above table to save/reset the configurations. Items Hide SSID 802. 11n Wireless advance Settings Information Select the mixed or green field mode as the Hyper Throughput operation mode. Select the 40MHz or 20MHz as the channel HT Channel Bandwidth bandwidth. Select 400ns or 800ns as the interval time. [. . . ] Select the log message size of 4, 8, or 32 Log Message Size Kbytes. Mark to enable the following Remote Log configuration, and clear to disable. Remote Log Server Address Fill in the sever address for remote log. Remote Log Server Port To enable/disable log to remote and local Log to Remote and Local * Please click on the Save Settings button or the Reset Settings button on the above table to save/reset the configurations. 41 Date/Time Settings This page allows users to configure the date and time of the router. [. . . ]