User manual ENCORE ENKVM-PS2

[. . . ] A VGA, SVGA, or Multisync monitor capable of the highest resolution that you will be using on any computer in the installation A PS/2 Mouse A PS/2 Keyboard Computers The following equipment must be installed on each computer that is to be connected to the system: · Before you begin, make sure that the power to all the devices you will be connecting has been turned off. You must unplug the power cords of any computers that have the Keyboard Power On function. [. . . ] Note: The ENKVM-PS2 by default links to the first computer you turn on. Hotkey Port Selection All Hotkey port switches begin with tapping the [Ctrl] key twice. Press and release the [Left shift] key, and then press the [Right shift] key. Auto Scan Interval Sets the Auto Scan interval to "n" second intervals - where "n" is a number from 1 ­ 4. Note: The "n" stands for the number of seconds that the focus dwells on a port before switching to the other one. Replace the "n" with a number between 1 and 4 when entering this hotkey combination. Action Unplug the keyboard from the Console Keyboard Port, then plug it back in. Wait five seconds; then plug the cables back in and turn the computers on. pressing Hot Keys Gets No Response* Hotkey sequence input incorrectly. Resend the Hotkey command ­ press and release each key in the sequence individually. [. . . ] To avoid this, only connect the mouse port or the keyboard port. If you connect the mouse port, you will need to use the notebook's keyboard when the notebook becomes the active computer. [. . . ]