User manual ENFOCUS SOFTWARE PITSTOP EXTREME 08

[. . . ] User Guide © 2008 Enfocus NV all rights reserved. Certified PDF is a registered trademark of Enfocus NV; patent pending. Enfocus PitStop Professional, Enfocus PitStop Server, Enfocus Instant PDF, Enfocus StatusCheck, Enfocus CertifiedPDF. net, Enfocus Instant Barcode, Enfocus PitStop Extreme, Enfocus PDF Workflow Suite, Enfocus LightSwitch, Enfocus FullSwitch, Enfocus PowerSwitch, Enfocus SwitchClient, Enfocus SwitchScripter and Enfocus Browser are product names of Enfocus NV. Acrobat, Distiller, InDesign, Illustrator, Photoshop, FrameMaker, PDFWriter, PageMaker, the Adobe logo, the Acrobat logo and PostScript are trademarks of Adobe Systems Incorporated. [. . . ] You can select this point with the Reference Point button. if you select the bottom left Reference Point, the bottom left corner of the bounding box is used as origin of the transformation. It will remain in place when scaling the selection. · 68 Horizontal / Vertical Offset Use the X Offset and Y Offset fields to set the horizontal and vertical position of the selection. · · When the ruler is on, the position is defined relative to the ruler's origin. When the ruler is off, the position is defined relative to the bottom left corner of your document. Width / Height Use the Width and Height fields to set the width and height of the selection (in the units defined in the Preferences, see General Units on page 159). Use the Scale X and Scale Y fields to scale the width and height of the selection to a percentage of the original width / height. Note: You can flip (mirror) your selection by adding a minus sign in the Scale X or Scale Y field. Use the Scale X field to mirror your selection horizontally, and the Scale Y field to mirror it vertically. Rotation Use the Rotation field to rotate your selection counter-clockwise. To rotate it clockwise, use the minus sign (e. g. to rotate it clockwise by 90 degrees, type "-90"). Shearing Use the Shear field to shear the selection by a certain angle. In the example below, shearing the selection on the left by 25 degrees gives the result on the right. By default, the selection is sheared to the right. To shear it to the left, use the minus sign. Enfocus PitStop Extreme User Guide 69 5. 3 Stroke Window The Stroke window can be used to put a line around open or closed paths. The stroke has his own paint that can be defined in the Paint window. Width The line width for the stroke. The line width is always symmetrical (the inside and the outside distance are the same). Cap The caps can be Butt, Round or Square. · · · With Butt caps the stroke is squared of at the end points of a path. With Round caps the stroke is rounded of at the end points of a path, thus prolonging it. With Square caps the stroke continues beyond the end points of the path and is squared of (at a distance equal to half of the line width). Join The join can be Mitered, Round or Bevel. This is similar to the cap, but is applied to joined paths. Miter Limit A miter corner closes in one point. [. . . ] Text units Units for all text related values. You can choose between: mm, cm, m, inch, point, mil, pica points, didot points, Q's, Bai's. Stroke units Units for all stroke related values. You can choose between: mm, cm, m, inch, point, mil, pica points, didot points, Q's, Bai's. [. . . ]