User manual ENGENIUS DURAWALKIE

[. . . ] Don't let a phone call distract you from working safely. If an emergency occurs, dial the emergency phone number. Remember: if you are in an area where your phone does not have a clear signal from the base, it is highly probable that the call may not go through. Locate the nearest landline telephone or other communications device to call for help. [. . . ] When an incoming call arrives, the ringer will ring or vibrate unless the ringer has been turned off. If the handset is not on the cradle, press any key (except END, and the Silent soft key) to answer. You can press SILENT (Left) soft key if you choose to ignore the call. Unlike turning off the ringer (from the handset menu), the SILENT key operation is valid only for the current call. If the LCD shows "Private" or "Unknown", the caller's information may have been blocked by the caller or the originating phone company. To end a telephone or intercom call, press END key or place handset into charger cradle. adjusting Receiver (Earpiece) Voice Volume 1. Voice volume can only be adjusted during a call. The new setting remains effective for all future calls until changed. When a call is in progress, it can be put on hold by pressing the HOLD (Right) soft key. When an intercom call arrives, the ringer will ring or vibrate unless the ringer has been turned off. Charge the battery when one or several of the following happen: a. Phone does not respond when a key is pressed. You can replace the handset battery after placing the call-in-progress on Putting the handset back to charger cradle as often as possible is recommended for best performance. You have 1 Missed call VIEW MENU If your handset(s) is purchased as part of a system, it has been preregistered with the base station at the factory. If Handset ID as "00, " that means it is a new handset or the ID has been erased. You need to register the handset with the base station. Press and hold the base's Registration (REG) button for 2 seconds until 4 LEDs light up. Press handset key "1", this completes the registration process. When you register the handset to BASE 10, the base will assign a handset ID between 12 and 19. The first two handsets registered will be given ID 11 and 12, which gives them administrator privileges. The handset has a 12 second registration timeout starting from the registration or deregistration option has been selected. [. . . ] Press "2" to view the last 10 phone numbers received, starting from the most recent one. (2) Save: press "2" to edit and save or save without editing into the phonebook. (3) View Number: press "3" to view the complete number if the phone number is longer than 14 digits. (4) No entries: the LCD displays "No entries" if there is no "Received call logs". [. . . ]