User manual ENGENIUS EP-490

[. . . ] Table of Contents User Manual WIRELESS SOLUTIONS PROVIDER EP-490 4-line Wireless Phone System EnGenius Customer Service United States: 1-888-735-7888 Canada: 1-888-397-2788 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 General Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Product Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Battery Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] An alert tone (double beep) every 30 seconds will remind the handset that a call is being on hold. If the operation (e. g. , call transfer) after putting a call on-hold fails, the held call may be dropped. You can power off the handset (e. g. , change battery) while call is on hold. After power on again, you can continue the call by pressing UNHOLD (Left) soft key or select "3" from the Option menu to terminate the hold state. Ending a Call To end a telephone or intercom call, press END key or place handset into charger cradle. 33 34 Mute 1. After a link is established, you can press Mute (Left) soft key to mute the handset microphone. When mute is active, the other end will not hear your voice, but still can speak to you. To leave the mute state, press "Unmute" (Left) soft key. Note: Mute is effective only for the current call. It is automatically turned off after the call is ended. 1. Charge the battery when one or several of the following happen: a. Phone does not respond when a key is pressed. Talk range shortfall is experienced. 2. You can replace the handset battery after placing the call-in-progress on hold. 3. Battery talk time and standby time vary depending on the talk/standby pattern and the operating distance. Putting the handset back to charger cradle as often as possible is recommended for best performance. Note: Use only manufacturer provided batteries and charger. Do Not Disturb (Silent Ring) 1. Enter the key sequence MENU ­ Sounds ­ Ring Volume, then select "Off". This will turn off the ringer until it is turn on again from the menu. For temporary silencing the ringer when an incoming call arrives, press Silent (Left) soft key. Key Guard 1. To prevent accidental dialing, you can press Menu (Right) soft key, then select KeyGuard option. No key entry is accepted except the power on/off key. To unlock the keypad, press "Unlock" (Left) soft key, then, within 2 seconds, press the digit "1" to unlock. [. . . ] When finished, press SAVE (Left) soft key to save change. Press OPTION (Right) soft key to erase or edit the current message: i. Press "1" and confirm to erase message. Subsequent messages will be moved up in the Outbox. [. . . ]