User manual EPSON ACTIONLASER 1100

[. . . ] They may he very hot if the printer has been used recently. 4. Mount the SIMM in the slot provided for it. Now you need to update the printer driver's Memory Controller hardware CPU: RAM: 68HC000, 16 MHz 1MB expandable to 5MB Environmental Temperature: Humidity: Altitude: Operation: Storage: Operation: Storage: 41° to 95° F (5° to 35° C) -4° to 104° F (-20° to 40° C) 15 to 85% RH 5 to 95% RH 8200 feet (2500 meters) maximum Options Single In-Line Memory Modules (SIMMs) You can install one additional SIMM with a capacity of 1, 2, or 4MB. This allows you to increase memory capacity up to 5MB. setting. [. . . ] The EPSON Control Panel for DOS consists of five screens: Page Setup, Font, Quality, Memory, and Options. One screen is displayed at a time, and other screens are represented by buttons to the left of the current screen. The five screens are listed below, along with the items available on each. Menu Page setup Items Copies Lines per Page Orientation Paper Feed Paper Size Auto Continue Typeface Point Symbol Set Toner Saving Edge Smoothing Toner Density Page Protection Image Compression Power Save Mode Power Save Interval Font Quality When you choose the Options button, you see the following dialog box, which allows you to control additional settings. Memory Options Mode: 0 On Interval: 115 min. 0 Off Laser Printers 8/15/94 AL1100-3 EPSON ActionLaser 1100 Status and Error Messages Status, error, and caution messages appear on screen to notify you of the printer status and alert you to problems. Error messages tell you how to correct any problems that occur. Loading Paper To load a stack of paper in the printer's paper tray: 1. Remove any paper remaining in the paper tray. Pull the paper release lever toward the front of the printer. Front Panel Lights The two lights on the front panel allow you to monitor the status of the printer. The green Ready light is on when the printer is on and is ready to receive print data. As data is received from the computer, the Ready light flashes. The orange Error light indicates an error condition. If the Error light is on continuously, it indicates that no paper is loaded or that there is a paper feed jam. A flashing Error light indicates one of the following: an internal paper jam has occurred, the front cover is open, or the toner cartridge is not installed. Other status conditions are indicated by the combination of the Ready and Error lights. The following table describes all status conditions that can be indicated by the printer's Ready and Error lights: Ready Off Slow flashing Flashing On Off Off 1 Error 1Off I Off 1Off Off On 1 Flashing Printer status 1Printer is off. 1 Printer is in power save mode 1 Print data is being received at the printer or has already been received. Either the paper tray is empty or there is a 1 paper feed problem. 1One of the following errors has occurred: . 1One of the following errors has occurred: . Printer is in manual feed mode and is 3. Fan a stack of paper and load the paper in the paper tray. Place the paper side you want printed face down in the paper tray. Up to 100 sheets can fit in the paper tray. Slide the paper guides against the paper stack so the paper fits loosely between them. [. . . ] Then remove the protective cap at the end of the cartridge. Gently shake the toner cartridge back and forth a few times to distribute the toner evenly. Slide the cartridge into the printer until it stops. Then push the cartridge firmly until it locks in place. [. . . ]