User manual EPSON ACULASER CX28

[. . . ] User's Guide NPD3982-00 EN Copyright Notice No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the information contained herein. Neither is any liability assumed for damages resulting from the use of the information contained herein. Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U. S. ) failure to strictly comply with Seiko Epson Corporation's operating and maintenance instructions. [. . . ] Original Size Specify the original size. Scale Specify the enlargement or reduction ratio for the selected area. If the resolution is set at 1200 1200dpi or higher, a setting larger than 100% cannot be specified. When Manual is selected, a tab appears so that detailed settings can be specified, for example, for Brightness/Contrast and Filter. The parameters that can be set differ depending on the scanning mode that is selected. If Auto is selected as the scanning mode, scanning from the original glass is performed after a prescan is performed so that a preview image can be checked. Scanning From a Computer Application 153 Image size Shows the data size of the scan image. Rotation Select the orientation of the image to be scanned. If the Rotate back side check box is selected, the back side of the image is rotated 180 and scanned. (Applies only if ADF (Duplex) is selected) Close Click to close the TWAIN driver window. Prescan Click to begin scanning a preview image. AutoCrop icon Click to automatically detect the scanning position based on the preview image. Zoom icon Click to rescan the area selected in the preview window and enlarge it to fit the window. Mirror icon Click to display a mirror image of the preview image. Tone Reversal icon Click to reverse the colors of the preview image. Clear icon Click to erase the preview image. Preview window Displays a preview image. Drag the rectangle over the image to select an area. Before/After (RGB) Move the pointer in the preview window to display the color tones at the pointer's position before and after adjustments. Width/Height Displays the width and height for the selected area in the selected measurement units. 154 Scanning From a Computer Application Windows WIA Driver Settings Paper source Select the paper source. Color picture Select this setting when scanning in color. Grayscale picture Select this setting when scanning in grayscale. Black and white picture or text Select this setting when scanning in black and white. [. . . ] Reposition it, making sure that the DIMM is seated completely in the connector. 6 7 8 9 Close the inside cover, and then tighten the screw. Reconnect the power cord, and turn on the machine. 10 11 Declare the additional Printer Memory in the Windows printer driver (Properties/Configure tab). Print a configuration page (REPORT/STATUS / REPORT / CONFIGURATION PAGE) and verify that the total amount of the RAM installed in your printer is listed. 270 Dual In-Line Memory Module (DIMM) Hard Disk Drive If you install a hard disk drive, the followings can be performed: Job printing/saving Fonts/forms/color profile download User Authentication Direct printing Installing the Hard Disk drive Note It's very important to protect the printer controller board and any associated circuit boards from electrostatic damage. Before performing this procedure, review the antistatic caution on page 267. [. . . ]