User manual EPSON C82391 NETWORK ADMINISTRATOR'S GUIDE

[. . . ] ® C82391 EpsonNet 10/100 Base Tx Int. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON product. EPSON is not responsible for any use of this information as applied to other products. [. . . ] For Windows NT 4. 0: Double-click Network in Control Panels and check that Server or Workstation is listed in the Services menu. For Windows NT 3. 51: Double-click Network in Control Panels and check that Server or Workstation is listed in the Installed Network Software list. 6-16 Settings for Windows 2000/NT 2. Open the command prompt of Windows NT and enter the following command. NET USE the printer port:\\the NetBIOS name of the interface card\the Device name of the interface card 3. From the server, setup the printer as a shared printer. To use the printer, clients need to select the printer port that you set in step 2. Windows Me/98/95: Open the target printer's properties, and select the port in the Details dialog box. Windows 2000/NT 4. 0: Open the target printer's properties, and select the port in the Ports dialog box. Windows NT 3. 51: Select the printer in the Print Manager, and select the properties from the Printer menu. From the Print to list box, select the target port. 6 Settings for Windows 2000/NT 6-17 Printing with IPP (Windows 2000 Only) This section explains about printing with Internet Printing Protocol (IPP) in Windows 2000. First, you need to set the IPP URL of the printer using EpsonNet WinAssist or WebAssist. Then set up the printer with the Add Printer Wizard. Configuring for IPP using EpsonNet WinAssist 1. Turn on the printer with the interface card. Run EpsonNet WinAssist from the Start menu. Select the printer you want to configure from the list, then click Configuration or double-click the printer. Note: If you have connected more than one printer to the network, you can distinguish between the printers by the MAC address on a status sheet. If the IP address is set to the default IP address, the printer model may not appear. You can search printers in other segments by setting the Search Options in the Tool menu in EpsonNet WinAssist. See"Optional settings" on page 10-4 for more information. 6-18 Settings for Windows 2000/NT 4. Click the IPP tab, and make the following settings. 6 IPP URL: Displays the IPP URL of the printer. http://the IP address of the printer:631/the printer name Printer Name: Enter the printer name to use with the IPP printing up to 127 characters. Location: Enter the name of the location where the printer is physically located up to 64 characters. Enter your password (up to 20 characters) and click OK to save settings. [. . . ] Click Start, point to Settings, and then click Network and Dial-up Connections. The Network and Dial-up Connections screen appears. Right-click the network connection for which you want to install and enable NetBEUI, and then click Properties. If NetBEUI Protocol is not in the list of installed components, click Install. [. . . ]