User manual EPSON C82405

[. . . ] ® EpsonNet 10/100 Base Tx High Speed Int. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson product. Epson is not responsible for any use of this information as applied to other products. [. . . ] See "About EpsonNet Internet Print" on page 196 for more details. Microsoft Network Shared printing 1. Click Start, point to Settings, and then select Printers. Select the Network printer server radio button and then click Next. The Connect to Printer dialog box appears. Select the printer you want to configure from the Shared Printers list. If you cannot select the printer, enter the following in the Printer box: \\NetBIOS name of print server\Device name of print server 5. Follow the on-screen instructions to set up the printer. See "Installing a printer driver" on page 135 if necessary. Chapter 5 Installing the Printer Driver 134 Installing a printer driver 1. Insert the Software CD-ROM shipped with the printer. Close the EPSON Installation Program screen if it appears. The Install From Disk dialog box appears. Select the CD-ROM drive for Drives, and then double-click the WINNT40 folder. Click OK in the Install From Disk dialog box. Select the model name of the printer, and then click Next. Note: Announce the share name to your clients so that they know the share name of the printer they want to use. If the Add Printer wizard prompts you to select either Keep existing driver or Replace existing driver, be sure to select the Replace existing driver radio button. Click Finish and then follow the on-screen instructions to complete the setup. When you print using Microsoft Network Shared printing in the Windows XP/Server 2003/2000/NT environment, see "Using the NET USE command" on page 136 for more details. Chapter 5 Installing the Printer Driver 135 Using the NET USE command If you are running Windows XP/Server 2003/2000/NT and using NetBIOS to connect to the print server, we recommend that you use the NET USE command, as follows: 1. Check that the following services are installed. Right-click the Network Neighborhood icon on the desktop and select Properties. Click the Services tab and check that Server or Workstation is listed. Run the command prompt and enter the following command. [. . . ] For information on how to install Universal Plug and Play, see the Windows Me online help. Note: Before using the Universal Plug and Play function, you must enable the Universal Plug and Play function in EpsonNet WinAssist or WebAssist. See "TCP/IP" on page 68 or "Configuring the Print Server Using EpsonNet WebAssist" on page 208. Appendix A Tips for Administrator 254 Uninstalling Software Follow the steps below to uninstall the network software. Windows Me/98/95/2000/NT 4. 0 1. Click Start, point to Settings, and then select Control Panel. [. . . ]