User manual EPSON DLQ-2000 ESCP MANUAL

[. . . ] Tear Off/Special Paper lights Flash when continuous paper is in the tear-off position. Only the right one is on when envelope is selected as the paper type. Only the left one is on when card is selected as the paper type. 2 Reset When you press both the Font and Pitch buttons simultaneously, the printer clears buffer and returns to its default settings. 3 Pitch button Selects one of the pitch settings. Pitch lights Indicate which pitch is selected. Buttons and Lights (1/2) EPSON DLQ-2000 Quick Guide 5 Paper Source button Selects a paper source. [. . . ] Otherwise, you may damage the printer or cause it to lose the top-of-form position. Do not open the printer cover while paper is being fed; otherwise the printer cannot load the paper correctly. 4. Slide the edge guide until it rests against the guide mark. Note: If the platen rotates but the printer does not load the paper, completely remove the paper and then insert it all the way into the printer again. If the paper feeds before you can adjust its position properly, increase the Manual feed wait time in the default-setting mode. See "Changing default settings" for more information. * guide mark Single Sheets with the Paper Guide (1/2) EPSON DLQ-2000 Quick Guide If you need to adjust the position of the paper after it is loaded, see "Adjusting the top-of-form position" and follow the instructions. After printing a sheet, the printer ejects it onto the paper guide and the Paper Out and Pause lights come on. If you are printing a multiple-page document, remove the printed sheet and insert a new sheet into the paper guide. The printer automatically advances the paper and resumes printing. Note: If the printer does not eject the printed sheet, press the Load/Eject button. Single Sheets with the Paper Guide (2/2) EPSON DLQ-2000 Quick Guide Single Sheets with the Cut-Sheet Feeder Loading paper to the cut-sheet feeder For single-sheet multipart forms, use only the type of forms that are glued at the top. To avoid paper jams, do not allow too many printed sheets to be stacked on the paper guide at one time. Remove the stack when it is half as thick as the paper loading limit marked on the cut-sheet feeder. Adjust the edge guide so that it is aligned with the guide mark on the paper guide. While aligning the left side of paper with the edge guide, insert it until it meets resistance. Be sure to load paper printable side up. After a few seconds, the printer automatically advances the paper to the loading position. The printer is ready to accept data from your computer and print. 7. Push back the paper set levers to clamp the paper against the guide rollers. Single Sheets with the Cut-Sheet Feeder (2/3) EPSON DLQ-2000 Quick Guide After printing a page of your document, the printer ejects it onto the paper guide and the Paper Out and Pause lights come on. If you are printing a multiple-page document, remove the printed sheet and insert a new sheet into the paper guide. The printer automatically advances the paper and resumes printing. Single Sheets with the Cut-Sheet Feeder (3/3) EPSON DLQ-2000 Quick Guide Single Sheets with the Automatic Sheet Alignment Unit Follow these steps to load paper using the automatic sheet alignment unit: 1. Make sure that Manual/CSF is selected as the paper source on the control panel. If not, select it by pressing the Paper Source button. Set the paper-thickness lever to the appropriate position for the type of single sheet you are using referring to the table in "Paper-Thickness Settings. " Normally set it to AUTO. [. . . ] Follow these steps to adjust the top-of-form position: 5. Press the LF/FF D button to move the top-of-form position down on the page, or press the Load/Eject U button to move the top-of-form position up on the page. Note: The printer has a minimum and a maximum top-of-form position. If you try to adjust it beyond these limits, the printer beeps and stops moving the paper. [. . . ]