User manual EPSON EB-1450UI INSTALLATION GUIDE (1.0)

[. . . ] XX(XXX) Español Français English Using the Product Safely Safety Instructions For your safety, read all the instructions in this guide before using this product. Incorrect handling that ignores instructions in this guide could damage this product or could result in personal injury or property damage. Keep this installation guide at hand for future reference. Read the User's Guide and Safety Instructions for your projector and follow the instructions in these documents. [. . . ] € Tightening the M8 bolt at the bottom lowers the setting plate, and loosening the bolt raises it. (You can also use a 17 mm socket wrench. ) After you finish making adjustments, tighten the M6 bolt that you loosened. 51 Installation Guide l Make sure that all of the bolts that you loosened in steps 6 to 11 are securely tightened Warning Tighten all bolts and screws firmly. Otherwise, the product may fall and cause personal injury or property damage. M Adjust the focus to match the focus in the following figure ( Open the air filter cover, and then adjust the focus. When ( ) is in focus, check the ( ) areas are uniform. If any of the ( ) ) areas are out of focus, adjust the focus After you finish making adjustments, close the air filter cover. N Press the [Esc] button on the remote control or the control panel to remove the guidance screen Sticking the infrared deflectors (EB-1460Ui/EB-1450Ui only) When installing the Touch Unit, if there are any obstacles at the bottom of the whiteboard such as a frame or trays, touch operations will not operate correctly. If there are any obstacles , stick the infrared deflectors along the bottom edge of the whiteboard before adjusting the position of the projector. 52 Installation Guide c • Do not remove an infrared deflector once it has been stuck in place. This can weaken the adhesive strength of the tape. € Do not stick tape or place anything on the infrared deflectors. The infrared deflector will not function correctly. Arc Correction When fine-tuning the shape of the projected image, perform Arc Correction. A Turn on the projector, and then press the [Menu] button Using the Remote Control Using the Control Panel b Select Geometry Correction from Settings 53 Installation Guide c Select Arc Correction d Select Arc Correction e Select the side you want to correct f Correct the selected side If the message "Cannot adjust any further. "is displayed while adjusting, you cannot adjust the shape any further in the direction indicated by the gray triangle. G Repeat steps 5 and 6 as needed to adjust any remaining sides Calibrating the pen Check that adjusting the position of the projector is complete before you start calibrating the interactive pen. S "Adjusting the Position of the Projector" p. 46 54 Installation Guide There are two methods available for calibrating the pen; Auto Calibration and Manual Calibration. When calibrating the pen for the first time after installing the projector, perform Manual Calibration for optimum calibration. For the Auto Calibration method, see the projector's User's Guide (on the Document CD-ROM). [. . . ] If the USB flash drive contains data other than the batch setup file, the settings may not be reflected copied correctly. C While holding down the [Menu] button on the remote control or the control panel, connect the power cord to the projector The status indicator and the power indicator turn blue, and the lamp indicator and the temperature indicator turn orange. When all of the projector's indicators turn on, release the [Menu] button. The indicators turn on for approximately 75 seconds. [. . . ]