User manual EPSON EB-595WI INSTALLATION GUIDE

[. . . ] Installation Guide Guide d’installation Guía de instalación Español Français English Using the Product Safely Safety Instructions For your safety, read all the instructions in this guide before using this product. Incorrect handling that ignores instructions in this guide could damage this product or could result in personal injury or property damage. Keep this installation guide at hand for future reference. Read the User's Guide and Safety Instructions for your projector and follow the instructions in these documents. [. . . ] € When connecting to the Audio1, Audio2, and Computer1 ports, we recommend connecting cables to the ports in the following order: Audio1, Audio2, and then Computer1. Adjusting the Projected Image Follow the procedures below to adjust the projected image. 41) Adjusting the Projection Position • Do not make adjustments using the projector's Keystone function. Doing so may result in a reduction in image quality. € When setting up multiple projectors using the batch setup function, perform this procedure before adjusting the projected image. 66 a Press the [t] button on the remote control or the control panel to turn on the projector Using the Remote Control Using the Control Panel Caution While projecting, do not put your face or hands near the air exhaust vent, and do not place objects that may become warped or damaged by heat near the vent. Hot air from the air exhaust vent could cause burns, warping, or accidents to occur. 34 Installation Guide b Change the aspect ratio of the projected image (only when necessary) Project images from a connected device, and then press the [Aspect] button on the remote control. Each time you press the button, the aspect name is displayed on the screen and the aspect ratio changes. Using the Remote Control c • For details on connecting to devices and projecting images, see the Quick Start Guide. € The aspect ratio does not change when no images are being projected from the connected device. € You can also change the aspect ratio from Signal - Aspect from the Configuration menu. S Projector's User's Guide - Configuration menu c Press the following buttons to display the guidance screen • Using the Remote Control Press the [Help], and then press [ ]. € Using the Control Panel Press the [Help], and then press the [Wide] button. 35 Installation Guide d Open the air filter cover, and then adjust the focus using the focus lever After you finish making adjustments, close the air filter cover. E Loosen the M4 screw (x1) with the hexagon wrench, and then adjust the horizontal roll with the adjustment dial c Repeat steps 5 to 10 as necessary. After you finish making adjustments, tighten the M4 screw that you loosened. 36 Installation Guide f Loosen the M4 screws (x2) with the hexagon wrench, and then adjust the horizontal rotation with the adjustment dial After you finish making adjustments, tighten the M4 screws that you loosened. G Loosen the M4 screw (x1) with the hexagon wrench, and then adjust the vertical tilt with the adjustment dial After you finish making adjustments, tighten the M4 screw that you loosened. 37 Installation Guide h Loosen the M4 bolts (x2) with the hexagon wrench, and then adjust the horizontal slide After you finish making adjustments, tighten the M4 bolts that you loosened. I Loosen the M4 bolts (x2) with the hexagon wrench, and then adjust the forward/backward slide After you finish making adjustments, tighten the M4 bolts that you loosened. 38 Installation Guide j Loosen the M6 bolt (x1) with the open-ended spanner, and then adjust the vertical slide Adjust the vertical slide with the hexagonal axis at the top or the bottom. [. . . ] When all of the indicators start flashing, the settings are being written. Caution Do not disconnect the power cord from the projector while the settings are being written. If the power cord is disconnected, the projector may not start correctly. When writing completes normally, the projector turns off, and only the power indicator is lit blue. [. . . ]