User manual EPSON ECOTANK ET-2750

[. . . ] You may see the following lights turn on or flash on the control panel: The top light turns solid green when the product is connected to a wireless network or flashes when the product is communicating with the wireless network. The bottom light turns solid orange when the product’s Wi-Fi Direct network is active. The lights flash alternately or simultaneously while initializing, trying to connect to a network, or if there is a problem with the product’s wireless connection. Indicates the status of the initial ink charge. [. . . ] Prolonged use of the product when the ink level is below the lower line on the tank could damage the product. Transporting Your Product If you need to transport or ship your product, see the online User’s Guide for important handling instructions. Note: Make sure the ink tank caps are closed securely. Avoid tilting the product, placing it vertically, or turning it upside down; otherwise, ink may leak. Do not put opened ink bottles in the box with the printer. Solving Network Problems If you have a network problem with your ET-2750, check the messages on the LCD screen to diagnose the cause of most problems. For the ET-2700, the lights on the control panel indicate the nature of the problem. You can also check the basic troubleshooting suggestions below. For more in-depth troubleshooting, see your online User’s Guide or FAQs at www. –  ■ ■ Try connecting to the wireless router or access point with your computer or another device to confirm that it is working correctly. The product can only connect to networks that support 2. Try restarting the router (turn it off and then on), then try to connect to it again. Checking Ink Levels 5 ■ ■ Verify that the network settings are correct and check the signal strength. If it is poor, try moving the product closer to your router or access point. ET-2750: Print a network status sheet from the Settings menu on the product’s control panel. –  ET-2700: If you are connecting the product via Wi-Fi Protected Setup (WPS) and the WiFi light on your product is not solid green, make sure you press the Wi-Fi button on the product within 2 minutes of pressing the WPS button on your router. Hold down the Wi-Fi button on the product for 3 seconds. remove and reinstall your product software. –  Notices Printing Guidelines This printer is not intended for dedicated borderless printing. Parts necessary for borderless printing have a limited service life. Excessive borderless printing may impact your ability to use other printer functions. declaration of Conformity According to 47CFR , Part 2 and 15 for: Class B Personal Computers and Peripherals; and/or CPU Boards and Power Supplies used with Class B Personal Computers: We: Located at: Telephone: Epson America , Inc. [. . . ] If a claimed defect cannot be identified or reproduced, you will be held responsible for the costs incurred. Arbitration, Governing Laws: Any dispute, claim or controversy arising out of or relating to this warranty shall be determined by arbitration in Los Angeles County, California before a single arbitrator. The arbitration shall be administered by JAMS pursuant to its Comprehensive Arbitration Rules and Procedures. Judgment on the award may be entered in any court having jurisdiction. [. . . ]