User manual EPSON EMP-3300

[. . . ] See the "Glossary" section of the "Appendices". s p. 65 Indicates operating methods and the order of operations. The procedure indicated should be carried out in the order of the numbered steps. Indicates the name of the buttons on the remote control or the control panel. [. . . ] : Projection in progress Indicates the projection lamp status. Indicates the internal temperature status. Refer to the following table to see what the indicators mean and how to remedy problems that they indicate. If all indicators are off, check that the power cable is connected correctly and that the power is being supplied normally. Sometimes, when the power cable is unplugged, the t indicator remains lit for a short period, this is not a fault. Problem Solving Abnormal 43 f t Power indicator lights red Status Red Red Red : Lit Cause Internal Error : Flashing: : Off Remedy or Status Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the World-Wide Warranty Terms. s Inquiries Red Red Fan Error Sensor Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the World-Wide Warranty Terms. s Inquiries Red Red High Temp Error (overheating) Red Red Lamp Error Lamp Failure Lamp Cover Open The lamp turns off automatically and projection stops. After about five minutes the projector switches to standby mode, so check the following two points. · Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall. · If the air filter is clogged, clean or replace it. s p. 54, 59 If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the World-Wide Warranty Terms. s Inquiries When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". The power cable is not connected correctly or power is not being supplied normally. Connect the projector's power cable correctly. sQuick Start Guide Check that your electrical outlet or power source is functioning correctly. Press the [A/V Mute] button on the remote control to cancel A/V Mute. s"Reset"-"Reset All" p. 39 Some input images, such as screen savers, may be completely black. Change the setting according to the signal for the connected equipment. s"Signal"-"Video Signal" p. 33 Is A/V Mute active?Are the configuration menu settings correct?Is the projected image completely black?Only when projecting computer images Is the image signal format setting correct?Only when projecting images from a video source f Moving images are not displayed Check Is the computer's image signal being output to the LCD and the monitor? [. . . ] 8, 63 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 71 Sports . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 sRGB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Standby mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]