User manual EPSON EMP-6100

[. . . ] S-Video port Video port (yellow) To video out port yellow white red A/V cable (commercially available) red white Audio port When connecting to video equipment with an composite video out port To audio out port * To output sound from the video equipment through the projector's in-built speaker, connect the video equipment and the projector with the an A/V cable (white/red), or an RCA audio cable. p If connecting a component video source (such as a DVD player), you can use the optional component video cable to connect the source to the Computer/Component Video port at the rear of the projector. s User's Guide "Turning on the Projector" Quick Start Power indicator 5 1 2 3 Remove the lens cover. Connect the projector's power cable with the projector. [. . . ] Connect the projector's power cable with the projector. Insert the power cable into a wall socket. Turn on the power for the signal input source. For video equipment, press [Play] to start playback. Press the [Power] button to turn on the projector's power. A beep will sound indicating the lamp has been turned on. The Power indicator begins to blink green, and projection will then start (warm-up in progress). p · If no images are projected, change the input signal. Remote control Projector · When using a laptop or a PC with an inbuilt monitor, select external video output on the computer. · s User's Guide "Selecting the Input Source" Adjustments · Adjusting the image angle Raise the front of the projector while pressing the feet buttons on both sides. Setup examples Press and hold the [Fn] key, followed by the appropriate function number key. NEC Panasonic Toshiba IBM [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] SONY Fujitsu Macintosh [Fn]+[F7] [Fn]+[F10] After start up enable "Mirroring" in the Monitors Control Panel. s User's Guide "Laptop connection" · Checking the indicators These indicators alert you to problems with projector operation. s Refer to "When You Suspect a Problem" in the User's Guide for further details. Warning indicator Condition lit Cause/Remedy flashing Red Power indicator Condition Orange lit flashing Red High internal temperature (overheating) The lamp will turn off automatically and projection will stop. Wait for about 5 minutes, unplug the power cable and then plug it back in again. Then press the [Power] button to turn the projector back on. Cause/Remedy Standby state The power cable should only be disconnected in this condition. Projection starts when you press the [Power] button. Cool-down in progress The projector changes to standby (indicator lights orange) after about 20 seconds. Projection in progress Warm-up in progress After warm-up finishes, projection starts when an image signal is input. Lamp problem Remove the lamp and check if it is broken. If the lamp is not broken, re-install it. [. . . ] Cool-down in progress The projector changes to standby (indicator lights orange) after about 20 seconds. Projection in progress Warm-up in progress After warm-up finishes, projection starts when an image signal is input. Lamp problem Remove the lamp and check if it is broken. If the lamp is not broken, re-install it. [. . . ]