User manual EPSON EMP-713

[. . . ] The documentation for your EPSON projector is divided into the following three manuals. Safety Instructions/World-Wide Warranty Terms This manual contains information on using the projector safely, and also includes World-Wide Warranty Terms and a Troubleshooting check sheet. Be sure to read this manual thoroughly before using the projector. owner's Manual (this manual) This Owner's Manual contains information on installing the projector , basic operation , using the projector menus , troubleshooting and maintenance. [. . . ] the lamp goes off automatically and projection becomes impossible. Wait for approximately 5 minutes with the projector in that state. After 5 minutes has passed, pull out the power plug once, then insert it again. If the projector overheats, check the following 2 points and make the necessary improvements. Make sure the air intake and exhaust vents are not covered, and that it is not placed up against the wall. When the power plug is reinserted, the projector will recover to the normal state, so press the power button and turn on the power again. If the projector overheats again even when the above measures have been taken, and when an error is displayed in the indicator when the power is turned on again, discontinue use, Pull the power plug out of the receptacle then request repairs by the retail shop where you purchased it, or by the service office at the nearest address provided at "International Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package. There is a problem with the cooling fan or temperature sensor. Pull the power plug out of the receptacle then request repairs by the retail shop where you purchased it, or by the service office at the nearest address provided at "International Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package. The eight projector menus let you to control your projector. The Video menu controls the look and quality of the projected image, whether the image source is a computer or video. The User's Logo menu lets you select special features such as background color or a custom logo. The About menu provides information about H/ V(Horizontal/Vertical) frequency, and lamp hours etc. Press the Menu button again to hide the menu. Press the top or bottom of the Enter button to scroll through the menu choices. Note: The options available in some submenus vary, depending on whether the current image source is the computer or a video source. Press the top or bottom of the Enter button to scroll through the menu choices. When you are finished changing settings, press the Menu button again to hide the menu, or press the Esc to go back to the Main menu. The following options are available when the image source is Computer. Note: The computer must be connected and operating, and the image source on the projector must be set to Computer for you to access these menu options. Menu item Position Description Select this item by pressing the Enter button to enter the screen position adjustment mode. Then use the Enter button to move the screen position in the corresponding direction. [. . . ] According to 47CFR, Part 2 and 15 for Class B Personal Computers and Peripherals; and/or CPU Boards and Power Supplies used with Class B Personal Computers Declare under sole responsibility that the product identified herein, complies with 47CFR Part 2 and 15 of the FCC rules as a Class B digital device. Each product marketed, is identical to the representative unit tested and found to be compliant with the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as required by 47CFR 2. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ]