User manual EPSON EMP-83H QUICK START GUIDE

[. . . ] In such cases, you will need to purchase a separate adapter. Connecting to a Video Source User's Guide "Connecting to a Video Source" Turn off the power for both the projector and the video source before connecting them. S-Video port Video port (yellow) When connecting to a video source with an S-Video output port To S-Video output port S-Video cable (commercially-available) Audio 2 port To video output port To audio output port yellow white A/V cable (accessory) red yellow white red When connecting to a video source with a video output port * To output sound from the video equipment through the projector's built-in speaker, connect the video equipment and the projector with the accessory A/V cable (white/red). If connecting a component video source (such as a DVD player), you can use the optional component video cable to connect the source to the Computer/Component Video port at the rear of the projector. [. . . ] If connecting a component video source (such as a DVD player), you can use the optional component video cable to connect the source to the Computer/Component Video port at the rear of the projector. User's Guide "Turning On the Projector" Tip Preparation before Projecting Power indicator 1 3 2 5 1 2 3 4 Remove the lens cover. Insert the projector's power cable into the projector. Insert the power cable into an earthed electrical outlet. Turn on the power for the signal input source. For video equipment, press [Play] to start playback. Press to turn on the projector's power. The Power indicator will flash green, and projection will then start (warm-up in progress). To clear the display, press on the control panel. Help Menu Help for the image Help for the sound Language selection (Language) If the suggested solution in Help doesn't solve the problem, unplug the power from the wall outlet and contact your local dealer. [ ]: Select [ ]: Enter [ ]: Exit Checking the indicators These indicators alert you to problems with projector operation. The following tables show what the indicators mean and how to remedy problems that they indicate. Refer to "When Having Some Trouble" in the User's Guide for further details. (Warning) indicator Status Problem and remedy Lit Flashing Red Power indicator Status Lit Flashing Problem and remedy High temperature inside projector (overheating) The lamp will turn off automatically and projection will stop. Wait for about 5 minutes, unplug the power cable and then plug it back in again. Then press to turn the projector back on. Lamp problem Remove the lamp and check if it is broken. If the lamp is broken replace by a new lamp, or contact your local dealer for further advise. *1 Internal problem Stop using the projector and send it for service. If the temperature rises too high again, projection will stop automatically. [. . . ] *1 Internal problem Stop using the projector and send it for service. If the temperature rises too high again, projection will stop automatically. Check that the air filter and air exhaust vent are clear, and that the internal room temperature is not too high. Orange Standby condition The power cable should only be disconnected in this condition. [. . . ]