User manual EPSON EMP-TW100

[. . . ] The documentation for your EPSON projector is divided into the following four manuals. refer to the manuals in the order given below. Unpacking and Installation Guide This manual contains information on the procedures from unpacking the projector through to starting to use the projector, and also describes the included accessories. Safety Instructions/ World-Wide Warranty Terms This manual contains information on using the projector safely, and also includes safety instructions , worldwide warranty terms and a troubleshooting check sheet. [. . . ] The projector is provided with the following three indicators. These indicators alert you to problems with projector operation. The following tables show what the indicators mean and how to remedy problems that they indicate. Problem and remedy Stop using the projector, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. Fan problem/ Stop using the projector, disconnect the power cord from the Sensor problem electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. Lamp problem Replace the lamp with a new one. When replacing the lamp, check that the lamp and the lamp cover are securely installed. If the lamp or lamp cover is not securely installed, the projector power will not turn on. If the lamp is broken replace by a new lamp, or contact your local dealer for further advise. If replacing the lamp yourself, be careful to avoid pieces of broken glass. (Projection cannot be carried out until the lamp is replaced. Lamp operating This can happen when the main power switch at the rear of the p. 48 error projector was turned off before the cool-down period had finished the last time the projector was turned off, and it was then turned back on again before one hour had passed. When the cooling fan stops, turn off the main power switch and then turn it back on again. When the main power switch is turned back on, the projector will return to its previous state, so press the [Power] button on either the projector's control panel or the remote control to turn it back on. If the lamp operating error happens again when the power is turned back on, remove the lamp and check if the lamp is broken. Then turn on the main power switch at the rear of the projector and press the [Power] button on either the remote control or the projector's control panel. If the indicators still show a problem, stop using the projector, turn off the main power switch, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. Wait for about 5 minutes without operating the projector. 46 When the cooling fan stops, turn off the main power switch at the rear of the projector and then check the following two points and take any steps that are required. Check that the air inlet and air outlet are clear, and that the projector is not positioned against a wall. If the air filter is dirty, it should be cleaned. [. . . ] A type of image signal with a resolution of 1, 024 (horizontal) x 768 (vertical) dots which is used by IBM PC/ AT-compatible computers. The carrier signal which is contained in the color bar signal used in modern TV transmissions. The carrier signal which is contained in the color bar signal used in high-definition TV (HDTV) transmissions. According to 47CFR, Part 2 and 15 Class B Personal Computers and Peripherals; and/or CPU Boards and Power Supplies used with Class B Personal Computers Declare under sole responsibility that the product identified herein, complies with 47CFR Part 2 and 15 of the FCC rules as a Class B digital device. [. . . ]