User manual EPSON EMP-TW200

[. . . ] The documentation for your EPSON projector is divided into the following three manuals. ⷠSafety Instructions/World-Wide Warranty Terms This manual contains information on using the projector safely, and also includes World-Wide Warranty Terms and a Troubleshooting check sheet. Be sure to read this manual thoroughly before using the projector. Quick Reference Guide Contains an overview of the most commonly-used projector functions for easy reference. [. . . ] (Press the Help button again to cancel this function. ) Tip: If you cannot solve your problem using the Help function, consult the "Troubleshooting" section in this manual (See page 53). For functions in each menu, access the guide available under each menu. Tilt the Enter button up or down to move the pointer up or down. When pressing the Esc button, the settings will be saved and the menu returns to the top menu. Press the Menu button, use the Enter button to select "Video" from the top menu displayed, and press the Enter button to move to a submenu. tip: · When there is no video signal from a Computer / Component Video device, the "Video" menu is not available for settings. ⷠWhen there is no video signal from a Video device, only the "Mode" menu is available for settings. Use color temperature or RGB to create settings for the colors displayed on screen. RGB: Adjusts red, green, and blue intensity. This setting is used for projection from the rear of a screen. If it is not broken, reinstall it and then press the [Power] button on either the remote control or the projector's control panel. If the indicators still show a problem, stop using the projector, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "Safety Instructions/ World-Wide Warranty Terms" included in the package. If the lamp is broken, handle pieces carefully to avoid injury, and contact your dealer or the nearest address provided at "International Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package for repair (video projection is not possible unless the lamp is replaced). If the lamp or lamp cover is not attached securely, follow the replacement instructions to attach it securely. Flashing red (2-second intervals) Internal problem Stop using the projector, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in "Safety Instructions/WorldWide Warranty Terms" included in the package. The usage temperature range of the projector is 5°C­35°C, and the projector should be used in this range. Place the projector in a well-ventilated location where air inlets and air exhaust vent are not blocked. If the indicator is normal but you experience problems with video projection, refer to "When Indicators Do Not Help" on the following page. ⷠIf an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided at "International Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package. Have you turned the power off and then immediately on?See page 31 The Power button cannot be operated immediately after the projection has been switched off. [. . . ] When tracking is not matched, a projected image displays broad vertical bands. The carrier signal which is contained in the color bar signal used in modern TV transmissions (NTSC format). the name comes from the Y (luminance) signal and the CbCr (chroma [color]) signals. The carrier signal which is contained in the color bar signal used in high-definition TV (HDTV) transmissions. [. . . ]