User manual EPSON EXPRESSION PHOTO XP-750

[. . . ] Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product. Seiko Epson Corporation and its affiliates shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original EPSON Products or EPSON Approved Products by Seiko Epson Corporation. EPSON is a registered trademark of Seiko Epson Corporation, and Expression, ES-1200C, and Easy Setup are trademarks of Epson America, Inc. General Notice: Other product names used here in are for identification purposes only and may be trademarks of their respective owners. [. . . ] ERROR light (red) Comes on when an error occurs. Along with the READY light, it indicates the type of error. OPERATE button Turns the scanner on and off. RESET button Resets the scanner after an error occurs. Pressing this button during scanning stops the scanner and may cause an error in the scanning software. 2-2 Scanner Basics Scanner errors If an error occurs, the scanner stops operating and the READY and ERROR lights show the type of error. See Chapter 4, "Troubleshooting. " Placing a Document on the Scanner Remember to respect the rights of copyright owners. Do not scan published text or images without first checking the copyright status. Turn on the scanner by pressing the OPERATE button. The OPERATE light comes on. Before scanning a document: Scanner Basics 2-3 2. Turn on the computer and make sure that the scanner's READY light is on. Open the document cover. 3. Place the document on the document table, with the side to be scanned down. Make sure that the document is carefully aligned. 2-4 Scanner Basics 4. Close the document cover gently so that the document does not move. Note: 0 Make sure that the document is flat against the glass surface so that the image is properly focused. If the glass is stained with grease or other hard-toremove material, use a small amount of glass cleaner on a soft cloth to remove it. Wipe off any remaining liquid with a soft dry cloth. Be sure that there is no dust on the glass of the document table. Dust can cause white spots in your scanned image. 2-8 Scanner Basics Be careful not to scratch OY damage the glass of the d0c2md table, and a0 not use a hard OY abrasive brush to clean it. A damaged glass surface can decrease the scanning quality. 0 Never use alcohol, thinner, OY corrosive solvent to clean the scanner. These chemicals can damage the scanner components as well as the case. 0 Be careful not to spill liquid into the scanner mechanism OY electronic components. This could permanently damage the mechanism and circuitry. 0 Do not spray lubricants inside the scanner. 0 Never open the scanner case. Replacing the fluorescent lamp The luminosity of the fluorescent lamp declines over time. [. . . ] Also check that the image settings in your application are appropriate for the type of image you want to scan. (See your application software and Scanning Utilities manuals. ) A line of dots is always missing in the scanned image. If this happens in your printed image only, your printer or its print head is probably malfunctioning. (See your printer manual. ) If this happens on both your screen and printout, the scanner's sensor may be malfunctioning. Consult your dealer. When halftoning is used, textured patterns of dots appear on particular areas of an image. This is normal. [. . . ]