User manual EPSON GP-M831

[. . . ] 26 Accessing the printer driver from Windows applications. 27 Accessing the printer driver from the Start menu. 35 Setting whether the buzzer sounds when printing is finished. 35 Setting whether the buzzer sounds when an error occurs. [. . . ] When pressed for three seconds or more, the printer enters Micro Adjust mode*. The printer exits the mode when pressed again. Job Cancel button Cancels the print job when pressed for three seconds or more when the printer is paused. Right ink light ( Y, M, C) (GP-C830/GP-C831/GP-C832) ❏ Flashes when ink is low.  On when an ink cartridge has reached its replacement time or when the right ink cartridge cover is closed with an ink cartridge not installed. Right ink light ( K) (GP-M830/GP-M831/GP-M832) ❏ Flashes when ink is low.  On when an ink cartridge has reached its replacement time or when the right ink cartridge cover is closed with an ink cartridge not installed. * Micro Adjust mode: When you hold down the Pause button for three seconds, the printer enters Micro Adjust mode. In this mode, you can press the FF D and Load/Eject U buttons to adjust the top-of-form or tear-off position. For more information, see “Adjusting the top-of-form position” on page 24. Control Panel 54 GP-C830/GP-M830/GP-C831/GP-M831/GP-C832/GP-M832 User’s Guide Chapter 6 Troubleshooting Using the Error Indicators You can identify many common printer problems using the lights on the control panel. If your printer stops working and one or more control panel lights are on or flashing or the printer beeps, use the following table to diagnose and fix the problem. If you cannot fix your problem using this table, see “Problems and Solutions” on page 57. Panel light state Beep pattern Problem Solution N On N Paper O No paper is attached to the tractor unit or the paper is used up during printing. Attach the paper to the tractor, and then press the Load/Eject button. N On F Paper O The paper is not fully loaded. Remove the paper if there is a paper jam. Then, reattach the paper to the tractor and press the Load/Eject button. If the paper is advanced too far and ejection failed, press the Load/ Eject button again to feed the paper backward. However, to prevent a paper jam, do not feed the paper backward 558. If the length of the paper that you want to eject is longer than about 550 mm (22 inches), tear off the paper, and then press the Load/ Eject button. N On N Cover The top cover or ink cartridge cover is open. [. . . ] Microsoft , Windows , Windows Server , and Windows Vista are registered trademarks of Microsoft Corporation in the United States and/or other countries. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Epson disclaims any and all rights in those marks. The contents of this manual are subject to change without notice. [. . . ]