User manual EPSON L386 STARTUP GUIDE (1.0)

[. . . ] J If the Firewall alert appears, allow access for Epson applications. K Turn on the printer and wait until P stops flashing. Press y for 3 seconds until P starts flashing. Sn Visit the website to install Epson iPrint application, start the setup process, and configure network settings. [. . . ] D Slide the edge guide against the paper, then close the feeder guard. Indd A3 size 2016/06/08 Print Quality Help / Aide concernant la qualité d’impression / Ayuda sobre la calidad de impresión / Ajuda sobre a Qualidade de Impressão B QQ Checking Ink Levels and Refilling Ink / Contrôle des niveaux d’encre et recharge / Comprobación de los niveles de tinta y rellenado de tinta / Verificar os níveis de tinta e de reabastecimento Error Indicators / Voyants d’erreur / Indicadores de error / Indicadores de erro lights are on or flashing, QQ If the product stops working and theand solve the problem. : flashing / clignotant / intermitente/ intermitente : on / allumé / encendido/ ligada The paper is jammed in the rear paper feed. See the “Clearing Paper Jam” section to remove paper and resume printing. No paper is loaded, or multiple sheets were fed at the same time. Load paper in the rear paper feed correctly and press Aucun papier n’est chargé ou plusieurs feuilles ont été insérées en même temps. Follow steps B to M in section 3 of the front page to complete initial ink charging. If you see missing segments or broken lines in your printouts, try the following solutions. A Remove all of the paper inside, including any torn pieces. (a) A (b) cc Print a nozzle check pattern to check if the print head nozzles are clogged. Turn off the printer, and then turn it back on while holding down y and P. If you notice any missing segments or broken lines as shown in (b), go to step B. Do not touch the white flat cable, translucent part, and ink tubes inside the printer. If the ink level is below the lower line on the tanks, go to step B to refill the tanks. Cc Continuing to use the printer when the ink level is below the lower line could damage the printer. Make sure you visually check the ink levels. B Run print head cleaning until all lines are printed completely. Hold down y for 3 seconds until the power light starts flashing. Refer to steps B to I in section 3 of the front page to refill the tanks to the upper line. QQ Cleaning uses some ink from all tanks, so only run cleaning if print quality declines. QQ If paper still remains near the rear paper feed, gently pull it out. Ink the ink the ink tank up to the QQ If anyinstallremains insecurely bottle after fillingbottle upright for laterupper line, the cap and store the ink use. [. . . ] If ink gets on your skin, wash the area thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. If discomfort or vision problems continue after a thorough flushing, see a doctor immediately. If ink gets into your mouth, see a doctor right away. [. . . ]