User manual EPSON MOVIEMATE 72

[. . . ] Epson MovieMateTM 72 User's Guide Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson product. Epson is not responsible for any use of this information as applied to other products. [. . . ] Many of these settings are available by pressing the Setup or Visual Setup buttons on the remote control. Locking DVDs You can lock up to 40 DVDs to prevent children from viewing them. When a disc is locked, you need to enter a password before you can play it. You see the Language Setup Page: Audio Setup Others Setup 3. Press until you see the Others Setup Page. to highlight Disc Lock, then press to select Lock, then press to select New Password. to highlight Password, then press to change the setting. 8. Set the toggle switch on the remote control to the -123 position, then enter 6 digits using the numeric buttons. The first time you set a password, you need to enter enter 000000 in the Old Password column first, then enter the new password. Enter the same digits again for Confirm PWD using the numeric buttons. Once a password is set, you will need to enter it before you can view the locked CD or DVD. If you forget your password, enter 000000 in the Old Password column to reset the password. Doing More with Epson MovieMate 39 11. Press to exit the menu. Locking the Power Button on the Control Panel You can lock the button on the control panel to prevent young children from accidentally turning on MovieMate and looking into the lens. (You can still turn on MovieMate using the remote control, so you may want to place it out of children's reach. You will also be able to turn on MovieMate by holding down the button on the control panel for at least 5 seconds. Warning: Do not allow young children or pets to look into the projector lens when MovieMate is turned on. The lens projects bright light that may affect their vision. 1. Press to highlight Option, then press until you see Child Lock. or to select On, then press to exit the menu. . to select it. You need to restart MovieMate for the setting to take effect. Saving Power The power turns off automatically when a DVD is stopped for more than 30 minutes. You can select a time to turn off MovieMate while a movie is playing, in case you fall asleep while watching. Continue pressing the button to select from the following settings: SLEEP OFF: The power switches off automatically after 30 minutes of inactivity (default setting). SLEEP 10, 20, 30, 60, 90, 120, 150: The power switches off automatically after the number of minutes specified, whether or not a movie is playing. You can select from 10 to 150 minutes. 40 Doing More with Epson MovieMate After you set the sleep timer, you can see the time remaining by pressing Note: Sleep timer settings are not saved after you turn MovieMate off. . Changing Language Settings You can use the Language Setup Page to change the default language for DVDs that allow you to make this selection. [. . . ] Allow a few seconds for MovieMate to sync up. You see the message Signal not supported. Press the page 43). button on the remote control and check the Video Signal setting (see The picture is cut off (too large) or too small. Press the button on the remote control and select the appropriate aspect ratio. The picture is distorted. If you're using an extension cable, electrical interference may affect the signal. Check the solutions on pages 55 and 56. The colors are not right. Press the page 43). button on the remote control and check the Video Signal setting (see Press the button on the remote control to select the best setting for your viewing environment. Adjust the Color Saturation or Tint settings. [. . . ]