User manual EPSON OPTRA M412

[. . . ] M410 M412 Edition: May 2000 The following paragraph does not apply to any country where such provisions are inconsistent with local law: LEXMARK INTERNATIONAL, INC. , PROVIDES THIS PUBLICATION “AS IS” WITHOUT WARRANTY OF ANY KIND , EITHER EXPRESS OR IMPLIED , INCLUDING , BUT NOT LIMITED TO , THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow disclaimer of express or implied warranties in certain transactions; therefore, this statement may not apply to you. This publication could include technical inaccuracies or typographical errors. [. . . ] To load print material in an input tray: 1 Pull the input tray straight out of the printer. If you are loading the 250-sheet input tray, pull the input tray straight out and remove it completely from the printer. If you are loading the input tray for the optional 500-sheet drawer, pull the input tray straight out and remove it completely from the support unit. 124 Chapter 4: Using Print Materials 2 Press down on the metal plate until it locks into place. The metal plate remains stationary on the inside bottom of the input tray. Paper Size Indicators 3 Length Guide Move the length guide to the correct position for the size print material you are loading. € For the 250-sheet input tray, press down on the length guide tab with one hand, and with the other hand slide the length guide to the correct position for the size print material you are loading. Length Guide Tab Paper Size Indicators Loading Print Material 125 Length Guide Paper Size Indicators – For the 500-sheet input tray, lift the length guide straight up out of the input tray and replace it in the correct position. Insert the tabs located on each end of the length guide into the slots on the side of the input tray. Note: These examples show how to adjust for letter-size paper (LTR). The paper size indicators are paper size abbreviations used for placement of the length guide as shown. 4 Width Guide Tab Width Guide Press down on the width guide tab and slide the width guide to the far right side of the input tray as shown. 126 Chapter 4: Using Print Materials 5 Flex the sheets back and forth to loosen them, then fan them. Do not fold or crease the print material. Straighten the edges on a level surface. 6 Place the print material against the left side of the input tray and insert it under the metal stop. Make sure the recommended print side is face down and the front edge is placed toward the front of the input tray. For information on loading letterhead, see “Printing on Letterhead” on page 135. Metal Stop Note: Make sure the print material fits easily under the metal stop and is not bent or wrinkled. Do not raise the metal stop or force print material under the metal stop. Loading Print Material 127 7 Do not exceed the maximum stack height indicated by the line under the arrows. Note: Overfilling the input tray may cause paper jams. [. . . ] A parallel printer protocol where the printer receives information sent from the computer at a normal transmission rate. A operator panel display message that provides information on the state of the printer. A unique set of alphanumeric characters and symbols that the printer uses to print the requested font. Different symbol sets offer the diverse characters required for different languages or symbol-intense applications. [. . . ]