User manual EPSON PERFECTION 1260 SETUP GUIDE

[. . . ] Leave the yellow sticker in place until you are instructed to remove it. A progress meter appears on the screen and your photo is automatically scanned. After your photo is scanned, the Scan for Creativity dialog box opens. If you want to scan another photo, place it on the document table, close the document cover, then click Scan More. [. . . ] It turns on when you connect the AC adapter and then plug in the power cord. Connect the square connector on the USB cable to the USB port on the back of the scanner. Connect the other end of the USB cable to any available USB port on your computer or USB hub. 2. Slide the transportation lock all the way to the right. Connect the power cord and AC adapter, as shown. Connect the AC adapter to the DC inlet on the back of DC inlet the scanner. Plug the other end of the power cord into an electrical outlet. Safety Instructions Connect this end of the USB cable to your computer. transportation lock USB port AC adapter Read all these instructions and save them for later reference. Follow all warnings and instructions marked on the scanner. c power cord The scanner turns on and the ] Start button comes on green. c Caution: It is not possible to change the AC adapter's input or output voltage. If the label on the AC adapter does not show the correct voltage, contact your dealer. Whenever you unplug the scanner, wait at least 10 seconds before plugging it back in. Rapidly plugging and unplugging the scanner can damage it. 7. Open the document cover and make carriage sure the fluorescent lamp on the (in the home position). This signifies that the scanner is ready for use. Note: To turn off the scanner, unplug the power cord from the electrical outlet. The scanner may not work properly if you use a USB cable other than the one supplied by EPSON, or if you connect to the computer through more than one hub. The fluorescent lamp turns off if you do not use the scanner for about 15 minutes. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. [. . . ] Do not place multiple loads on the electrical outlet. Never disassemble, modify, or attempt to repair the AC adapter, power cord, scanner, and option by yourself except as specifically explained in the scanner's guides. Do not insert objects into any openings as they may touch dangerous voltage points or short out parts. Beware of electrical shock hazards. Caution: Unplug the scanner and the AC adapter, and refer servicing to qualified service personnel under the following conditions: The power cord or plug is damaged; liquid has entered the scanner or the AC adapter; the scanner or the AC adapter has been dropped or the case damaged; the scanner or the AC adapter does not operate normally or exhibits a distinct change in performance. [. . . ]