User manual EPSON POWERLITE 732C

[. . . ] Epson PowerLite 732c/740c Multimedia Projector ® ® User's Guide Important Safety Information WARNING: Never look into the projector lens when the lamp is turned on; the bright light can damage your eyes. Never let children look into the lens when it is on. Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical voltages inside the projector can severely injure you. [. . . ] Unauthorized users cannot turn it off or change it. This feature is intended to discourage theft and provides a way to identify the projector should it be stolen. Enabling Password Protection note It's a good idea to write down your password. If you leave the projector plugged in, the Password Protect Release screen will not appear. You only need a password if you unplug and reconnect the power cable. To prevent unauthorized use, you can assign the projector a password. If you do, a screen will appear requesting the password whenever the projector is plugged in and turned on. If an incorrect password is entered three times in succession, the projector's operation is locked and the power cord must be disconnected and reinserted to redisplay the password screen. If an incorrect password is entered thirty times in succession, the user must contact Epson to unlock the projector. 52 Fine-Tuning the Projector The default setting for the Password Protect function is OFF. Follow these steps to turn password protection on: 1. Press the Freeze button on the remote control for about five seconds. Use the pointer button to set Power ON Protect to ON. When you see a message asking if you want to change the password, select Yes and press Enter. Hold down the Num button on the remote control and use the numeric keypad to enter a four digit password. When you see a confirmation message, reenter the password. Then press the Menu button to exit the screen. Press the Num button on the remote control to deactivate the numeric keypad. If you want to disable the password temporarily, select Timer and press Enter. Then hold down the Num button while you use the numeric keypad to enter the number of hours (from 0 to 9999) that you want the password feature disabled. If you want the projector to request the password every time it is turned on, set the timer to 0H. If you lose the remote control, you will not be able to enter the password. Keep the remote control in a safe place at all times. Fine-Tuning the Projector 53 The countdown for the elapsed time begins as soon as you close the Password Protect menu. (You can check the elapsed time in this menu next to Time elapsed. ) 10. To enable your screen logo, select User's Logo Protect and press Enter. When this feature is on, the logo appears whenever you turn on the projector (if the Startup Screen is enabled in the Extended menu; see page 55). [. . . ] When warranty service involves the exchange of the product or of a part, the item replaced becomes Epson property. The exchanged product or part may be new or previously refurbished to the Epson standard of quality, and at Epson's option, the replacement may be another model of like kind and quality. Epson's liability for replacement of the covered product will not exceed the original retail selling price of the covered product. Exchange or replacement products or parts assume the remaining warranty period of the product covered by this limited warranty. [. . . ]