User manual EPSON POWERLITE 811P

[. . . ] EPSON PowerLite 600p/811p/820p Multimedia Projector ® ® User's Guide Important Safety Information WARNING: Never look into the projector lens when the lamp is turned on; the bright light can damage your eyes. Never let children look into the lens when it is on. Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical voltages inside the projector can severely injure you. [. . . ] Your selections are saved. 52 Fine-tuning the Projector Creating Your Own Startup Screen You can transfer any image from your computer or video source to the projector, and then use it as your startup screen. You can also use it as the screen displayed when the projector is not receiving a signal or when you press the A/V Mute button. The image can be a company logo, slogan, photograph, or any other image you want to use. Capturing the Image Start by displaying the image you want to use. It can be an image from either a computer or video source such as a DVD player or digital camera. Then follow these steps to capture the image and transfer it to the projector: 1. Press the Menu button on the control panel or remote control. Use the Sync­ button (control panel) or the button (remote control) to highlight the User's Logo menu, then press . 3. When you see the screen shown at right, select Yes and press A selection box displays over the image. . 4. Use the Tracking and Sync buttons (control panel) or the button (remote control) to select the area of the image you want to use. Then press . Fine-tuning the Projector 53 5. When you see the message "Do you use this image?" select Yes and press . Use the Tracking and Sync buttons (control panel) or the button (remote control) to select a zoom rate (display size), and then press . When the message "Do you save the user's logo?" appears, select Yes and press . Do not use your projector or video source (computer, DVD player, etc. ) while the logo is being saved. When you see the message "Saving the user's logo is completed, " press Esc to return to the menu screen. Choosing When to Display the Image note You can also set up your image as the startup screen using the Advanced menu; see page 57. After your image is saved, you can set it up as the no-signal message and/or the screen that's displayed when you press A/V Mute. Press the Menu button to display the menu screen (if not already displayed). Sync­ button (control panel) or the 2. Use the (remote control) to highlight the Setting menu. button 3. Press the button to select the Setting menu. Sync­ button (control panel) or the 4. Use the button (remote control) to highlight either No-Signal Msg. or A/V Mute, depending on when you want the image to display. Tracking+ button (control panel) or the button 5. Use the (remote control) to select Logo. [. . . ] If a claimed defect cannot be identified or reproduced in service, you will be held responsible for costs incurred. THE WARRANTY AND REMEDY PROVIDED ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS 100 Appendix B: Notices FOR A PARTICULAR PURPOSE. SOME LAWS DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES. IF THESE LAWS APPLY, THEN ALL EXPRESS AND IMPLIED WARRANTIES ARE LIMITED TO THE WARRANTY PERIOD IDENTIFIED ABOVE. [. . . ]