User manual EPSON POWERLITE S3

[. . . ] Epson PowerLite S3 User's Guide Notations Used in This Guide 2 Indicates procedures which may result in damage or injury if sufficient care is not taken. Indicates additional information and points which may be useful to know regarding a topic. Indicates a page where useful information regarding a topic can be found. Click on the page number to display that page. Indicates that an explanation of the underlined word or words in front of this symbol appears in the glossary of terms. [. . . ] "Image" - "Color Intensity, " "Tint" sp. 35 Remedy Have the image brightness and luminance Use the "Brightness" and "Brightness Control" menu commands to adjust the brightness and luminance. "Image" - "Brightness" sp. 35 "Settings" - "Brightness Control" sp. 37 been adjusted correctly?Has the image contrastg been adjusted correctly?Use the "Contrast" menu command to adjust the contrast. "Image" - "Contrast" sp. 35 When the lamp is nearly due for replacement, the images will become darker and the color quality will become poorer. When this happens, the lamp should be replaced with a new one. sp. 61 Nothing appears on the external monitor Check Remedy Are images from a port other than the Computer port being projected? The only images that can be displayed on an external monitor are those from the Computer port. You cannot output video equipment images to an external monitor. sp. 68 Problem Solving 54 Problems when projection starts Power does not turn on Check Remedy Have you pressed the [Power] button?Are all of the indicators switched off? Press the [Power] button to turn the power on. The power cable is not connected correctly or power is not being supplied. Connect the power cable to the projector correctly. (See the Quick Setup sheet) Alternatively, check the circuit breaker to see if power is being supplied. Do the indicators turn off and on when the There is probably a poor contact in the power cable, or the power cable may be defective. If this does not solve the problem, stop using the projector, disconnect the power cable from power cable is touched?sp. 56 Other problems No sound can be heard or the sound is faint Check Remedy Is the audio source connected correctly?Has the volume been adjusted to the minimum setting?Is A/V Mute mode active? Check that the cable is connected to the Audio port. Adjust the volume so that sound can be heard. sp. 19 Press the [A/V Mute] button on the remote control to cancel the A/V mute function. sp. 22 Problem Solving The remote control does not work Check Remedy 55 Is the remote control facing towards the Face the remote control towards the remote control light-receiving area. remote control light-receiving area on the The operating angle for the remote control is approximately ±30º horizontally and approximately ±15º vertically. Is the remote control too far from the projector? [. . . ] Each product marketed, is identical to the representative unit tested and found to be compliant with the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as required by 47CFR 2. 909. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Compliance Statement For United States Users This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]