User manual EPSON STYLUS C110 SETUP SHEET

[. . . ] When a message appears prompting you to turn on the printer, press the P power button. The print head moves to the ink cartridge installation position and the Setup utility starts automatically. 2. Select the printer After you have installed the printer software, you need to select your printer. Press the P power button to turn on the printer. [. . . ] Press the P power button to turn on the printer. The print head moves to the ink cartridge installation position. Then, select the icon for your printer and the port that your printer is connected to. Close the Chooser. c Caution: Do not remove or tear the label on the cartridge; this can cause leakage. Do not touch the green IC chip on the side of the cartridge. Doing so may prevent normal operation and printing. Load paper and check the print head nozzles Make sure that the computer is turned on. Load paper into the sheet feeder making sure that the side of the paper that you wish to print onto is facing up and that the right edge of the paper is against the right edge guide. Next, slide the left edge guide so that it is against the left edge of the paper. printable side up left edge guide output tray extension For DOS Programs Most DOS software programs include a list of drivers including one for EPSON ESC/P 2TM Printers. In order to install the appropriate printer driver and enable your printer's advanced, built-in, scalable fonts and graphics handling, you must select the EPSON ESC/P 2TM printer from the list. If your printer is not included in the list, contact your software manufacturer to obtain an updated version of the software. Double-click the Install Software folder, then double-click the Installer icon inside it. After accepting the license agreement, Installer appears. c Install the ink cartridges 1. Lower the output tray, then open the printer cover. Caution: Do not turn the power off during the ink charging process. Do not load paper until ink charging is complete. For Macintosh users 1. Select Page Setup in the Finder's File menu. Click the Nozzle Check button, and follow the on-screen instructions. When you are finished, click OK to close the utility dialog box. Then click OK to close the Page Setup dialog box. Your printer is now set up and ready to use. Note: If the ink end error occurs after the print head moves to its home position, the ink cartridge may not be installed properly. Press the H ink button again, and reinstall the ink cartridge until it clicks into place. [. . . ] Then click OK to close the Page Setup dialog box. Your printer is now set up and ready to use. Note: If the ink end error occurs after the print head moves to its home position, the ink cartridge may not be installed properly. Press the H ink button again, and reinstall the ink cartridge until it clicks into place. When the ink charging process is finished, the P power light stops flashing and remains on. [. . . ]