User manual EPSON STYLUS C80N INSTALLATION GUIDE

[. . . ] EPSON Stylus C80N Getting Started Setup and Installation Guide Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers. [. . . ] In Windows 95, 98, and Me, click Add Port. In Windows NT 4. 0, 2000, and XP, if the port you want is already defined in the list, select it, click OK, and then go to step 6. If the port is not defined, click Add Port. 5. In Windows 95, 98, and Me, click Browse, then find the print server on the network. The name of the print server will vary depending on the network protocol used. Select the print server, click OK, then click OK to close the Add Port dialog box. In Windows NT 4. 0, 2000, and XP, select the type of port to add, then click New Port. What you do next depends on the type of port you are adding. Do what is required, close the Printer Ports dialog box, and then click OK. See the status sheet you printed out earlier (see page 13) for information you might need such as the NetBIOS name, the IP address, the name of the NetWare print queue, and so on. If you need to change the print server's configuration, use the WinAssist program (see page 16). For more information, see the Administrator's Manual. 6. Restart the computer. Installing the Printer Driver on Workstations 25 After the computer restarts, you may wish to turn off background monitoring, as described on page 35. Background monitoring is a feature of Status Monitor 3, a utility that installs with the printer driver. Status Monitor 3 permits each workstation to monitor the printer and check ink levels, but it also increases network traffic. To learn more about Status Monitor 3, see the next chapter. Installing the Printer Driver on a Macintosh 1. Turn on the printer and the Macintosh and turn off any running virus protection programs. Double-click the Printer Driver Installer folder. Double-click Stylus C80N Driver Installer. Follow the instructions on the screen, and then restart the computer when prompted. To use the printer or configure the print server, you need to select the C80 Series printer in the Chooser and make sure AppleTalk is turned on. See your Macintosh documentation for more information. 26 Installing the Printer Driver on Workstations Printing a Test Page On a Windows workstation, follow the steps below to test the printer and verify that network printing is working correctly. Make sure the printer is turned on and a sheet of letter-sized paper is loaded. [. . . ] Epson requires a debit or a credit card number to secure the cost of the replacement in the event that you fail to return the defective one. If your Product is being repaired, Epson will direct you to send it to Epson or its authorized service center. The Defective unit will be fixed and sent back to you. You are responsible for packing the unit and for shipping costs to and from the Epson authorized service center. [. . . ]