User manual EPSON STYLUS C82WN INSTALL GUIDE

[. . . ] EPSON Stylus C82WN ® Setup and Installation Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers. [. . . ] Before you start, make sure the printer is turned off. Connecting the Print Server 1. Slide the print server into the base and press firmly to attach it. 2. Locate the parallel cable included with the printer. Connect the larger end of the cable to the printer's parallel port. Then secure it with the wire clips. 3. Connect the other end of the cable to the parallel port on the print server and secure it as necessary. Configuring Wireless Printing for Macintosh 37 4. Connect the power supply to the print server. Plug the AC adapter into an electrical outlet. Both the green and yellow lights come on for a moment and then go out. Note: If the green light blinks continuously in a regular pattern, try unplugging the print server. If you still see the light blinking after you plug it in again, contact EPSON as described on page 52. 6. Press the P power button to turn on the printer. To test the connection between the print server and printer, press the test button for one second and release it. The status page prints. Note: If you hold the test button down, you may reset the print server. If you do this, wait for the print server's lights to go out, then press the button again and release it immediately to print the status page. If the print server status page prints, you're ready to configure your system for wireless printing. Make sure you save the status page for reference, and see the next section for instructions. If the status page doesn't print, make sure the printer is ready and is not out of ink or paper. Then turn off the printer, unplug the print server, and check the cable connections at both ends. Plug the server back in, turn on the printer, and press the test button again. If the status page still doesn't print, contact EPSON as described on page 52. 8. Check the following information on the status page: Note the WiFi Channel and Mode, and the Actual SSID. If the SSID does not match your network, your print server may be picking up signals from somewhere else. [. . . ] Epson is not responsible for warranty service should the Epson label or logo or the rating label or serial number be removed or should the product fail to be properly maintained or fail to function properly as a result of misuse, abuse, improper installation, neglect, improper shipping, damage caused by disasters such as fire, flood, and lightning, improper electrical current, software problems, interaction with non-Epson products, or service other than by an Epson Authorized Servicer. If a claimed defect cannot be identified or reproduced, you will be held responsible for the costs incurred. THE WARRANTY AND REMEDY PROVIDED ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR 60 Appendix B: Specifications and Notices PURPOSE. SOME LAWS DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES. [. . . ]