User manual EPSON STYLUS COLOR 777

[. . . ] EPSON Stylus Color 777/777i Printer Basics Printed on recycled paper. Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers. [. . . ] If necessary, load or reload paper and press the b maintenance button. If paper is jammed, press the b maintenance button to try to clear the jam. If that doesn't work, turn off the printer and gently pull out all the paper. Turn on the printer and press the b maintenance button to resume printing. When the b error light is on and your paper is loaded correctly and not jammed, you need to replace an ink cartridge. Determine which cartridge is out of ink and replace the cartridge as described on page 21 and page 22. b is on b flashes P is off and b is on When the b error light flashes, your ink supply is low. Determine which cartridge is low as described on page 22 and make sure you have a replacement cartridge. When the Ppower light is off and the b error light is on, jammed paper may be blocking movement of the print head. Turn off the printer, open the cover, and check inside for any jammed paper. If the lights are still in the same state, contact your dealer or EPSON; see page 37 for contact information. 28 P and b flash When both lights flash as you're replacing an ink cartridge, the flash pattern indicates which cartridge is low on ink, as described on page 22. If you're not replacing ink but both lights are flashing, your printer may have an internal error. Turn off the printer, wait a few seconds, and turn it on again. If the lights still flash, contact your dealer or EPSON; see page 37 for contact information. P and b are off When both lights are off, the printer is not receiving power. Try these solutions: s s s Make sure the printer is turned on. Turn off the printer, plug in the power cord securely, and turn on the printer again. Make sure the outlet is operable and is not controlled by a switch or timer. If in doubt, try using another outlet. Running a Printer Check You can run a printer check to determine whether a problem comes from the printer itself or some other source. Make sure both the printer and computer are turned off. Disconnect the interface cable from the printer. Make sure letter-size or larger paper is loaded in the printer. Hold down the b maintenance button, then press and release the Ppower button. Continue holding down the b maintenance button until the Ppower light starts to flash, then release it. [. . . ] If your printer is being repaired, Epson will direct you to send your printer to Epson or its authorized service center. The printer will be fixed and sent back to you. You are responsible for packing the printer and for shipping costs to and from the Epson authorized service center. When warranty service involves the exchange of the product or of a part, the item replaced becomes Epson property. The exchanged product or part may be new or refurbished to the Epson standard of quality. [. . . ]