User manual EPSON STYLUS COLOR 800

[. . . ] Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U. S. ) failure to strictly comply with Seiko Epson Corporation's operating and maintenance instructions. Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original EPSON Products or EPSON Approved Products by Seiko Epson Corporation. EPSON, EPSON Stylus, and EPSON ESC/P are registered trademarks and EPSON ESC/P 2 is a trademark of Seiko Epson Corporation. EPSON Connection is a service mark of Epson America, Inc. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. [. . . ] If ink gets into your eyes, flush them immediately with water. Maintenance and Troubleshooting 3-5 6. Remove the new ink cartridge from its foil package and remove the tape seal from the top of the cartridge. black cartridge color cartridge c Caution: You must remove the tape seal from the cartridge. Leaving the tape on will permanently damage it. 7. Lower the ink cartridge into its holder with the label facing up and the arrow on the top of the cartridge pointing to the back of the printer. The larger (color) cartridge goes on the left. 3-6 Maintenance and Troubleshooting 8. Push down the ink cartridge clamp until it locks in place. 9. Clean the print heads to ensure that ink is properly delivered to each nozzle. Cleaning is recommended but not required. If you replaced the black cartridge, hold down the Alt button while you press the Load/Eject (or Black) button. If you replaced the color cartridge, hold down the Alt button while you press the Economy/Condensed (or Color) button. After you clean the print head(s), skip to step 11. Repack the printer and attachments in the original box. Keep the printer flat during transport. Maintenance and Troubleshooting 3-9 If you notice problems with the printed image after transporting the printer, clean the print heads as described at the beginning of this chapter. If your printed images are misaligned vertically, calibrate the printer as described in the Setup and Software Guide. Troubleshooting This section describes what you can do if you are having problems printing. It is divided into the following sections: u Error lights. See this section to identify a problem indicated by the control panel lights. See this section if the print quality is not good or not what you expect. See this section if your printer is not printing. See this section if you have paper jams or other problems with paper feeding incorrectly. u u u If you have a printing problem, check the appropriate section and follow all suggestions that apply to your problem. Also check the ReadMe icon on your Macintosh hard disk or in the Windows EPSON group for the latest information. If none of the suggested solutions solve your problem, call (800) 922-8911 in the U. S. and Canada. 3-10 Maintenance and Troubleshooting Error Lights Certain problems are identified by the control panel lights. [. . . ] ESC/P 2 Enhanced version of the ESC/P® printer command language. ESC/P is the EPSON Standard Code for Printers. The system of commands sent by the computer to control the printer. It is standard for all EPSON printers and supported by most application software for personal computers. [. . . ]