User manual EPSON STYLUS OFFICE BX310FN BASIC OPERATION GUIDE

[. . . ] ePSON® and EPSON STYLUS® are registered trademarks , and Exceed Your Vision is a trademark of Seiko Epson Corporation. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Epson disclaims any and all rights in those marks. Make sure the power cord meets all relevant local safety standards. [. . . ] If non-genuine ink cartridges are installed, the ink cartridge status may not be displayed. Print head cleaning uses ink from all cartridges, so clean the print head only if quality declines. If it does not improve after cleaning four times, leave the printer for at least six hours. If quality does not improve, one of the ink cartridges may need to be replaced. Press r Copy to select Copy mode, and then press x to enter the copy settings menu. You need to replace the following ink cartridge(s): XXX Press OK to replace the ink cartridges. If the error does not clear, remove the paper by hand. printer error Paper is jammed in the printer. Turn off the printer, open the scanner unit, and remove the paper. Make sure the cable is connected, then try again. If the error message still appears, make sure that scanning software is installed on your computer and that the software settings are correct. Make sure that no paper is still in the printer. if the error message still appears , contact Epson support. if the error message still appears , contact Epson support. Contact Epson support to replace ink pads before the end of their service life. When the ink pads are saturated, the printer stops and Epson support is required to continue printing. R & 46 Even if ink cartridges are expended, you can continue to use all functions except for print. The printer's ink pads are nearing the end of their service life. The printer's ink pads are at the end of their service life. O Some ink is consumed from all cartridges during the following operations: print head cleaning and ink charging when an ink cartridge is installed. O For maximum ink efficiency, only remove an ink cartridge when you are ready to replace it. Ink cartridges with low ink status may not be used when reinserted. [. . . ] If a moiré (cross-hatch) pattern appears on your copy, change the Reduce/Enlarge setting or shift the position of your original. Make sure you selected the correct Paper Size, Layout, Expansion, and Reduce/Enlarge setting for the loaded paper. R & 26 Make sure you loaded paper and placed the original correctly. R & 16, 17 If the edges of the copy or photo are cropped off, move the original slightly away from the corner. [. . . ]