User manual EPSON STYLUS PHOTO 870

[. . . ] EPSON Stylus Photo 870 EPSON Stylus Photo 1270 ® ® Printer Basics Printed on recycled paper with at least 15% post-consumer content. Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers. [. . . ] Your banner prints with 0. 12-inch (3 mm) margins on each side. Follow the steps on page 56 to remove and store your banner. The spaces between pages or print jobs on roll paper may vary, depending on the application you're using and the way you create your document. If you select Save Roll Paper when printing 4 × 6-inch images, you may create a space between each print job. Macintosh Instructions 1. To do this, open the Adobe Photoshop 5. 0 LE folder and double-click the Adobe Photoshop 5. 0 LE icon. Open your panoramic picture or banner document, or create a new one with Photoshop. (See Photoshop Help for instructions. ) 3. Size your panoramic or banner as necessary. If you want white borders on the top and bottom of your image, make your Canvas Size larger than your Image Size. (See Photoshop Help for instructions. ) 4. You see your Page Setup dialog box: Select your custom size Select Roll Paper Click Customize to create a custom size for your document Select Banner 52 5. Select these settings: s Roll Paper as the Paper Source; this leaves a margin of at least 0. 12-inch (3 mm) on both sides of your printout s s Banner as the Roll Paper Option Click the Customize button and enter the size of your panoramic or banner, name the size, and click OK. The custom size is automatically selected as the Paper Size setting. If you added margins to the top and bottom of your panoramic or banner, click the Save roll paper checkbox. This retains your margin and feeds less paper before your next print job on roll paper. If you want to print a cutting line at your page boundaries, select Cut Sheet Mode, then click the Print page frame checkbox. 6. You see your printer settings dialog box: Select Photo Paper Make sure PhotoEnhance is turned off 8. Select Photo Paper as the Media Type setting. Also make sure the PhotoEnhance setting is turned off. Your banner prints with 0. 12-inch (3 mm) margins on each side. Follow the steps on page 56 to remove and store your banner. The spaces between pages or print jobs on roll paper may vary depending on the application you're using and the way you create your document. If you select Save Roll Paper when printing 4 × 6-inch images, you may create a space between each print job. 53 Printing on Paper Cut From a Roll If you'll be printing on paper cut from a roll without using the roll paper holder, follow the steps below. Before loading the paper, cut it to the desired length of your image plus two inches for the necessary margins. Cut the edge cleanly, at a 90 degree angle in each corner, to ensure proper loading. [. . . ] Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. WARNING The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification of this device and may cause interference levels which exceed the limits established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment interface cable with this device. If this equipment has more than one interface connector, do not leave cables connected to unused interfaces. [. . . ]