User manual EPSON STYLUS PHOTO R360

[. . . ] Check the label on the back of the printer to make sure the voltage required by the printer matches that of the electrical outlet you will be plugging it into. Also, make sure that you have the correct power cable for your power source. Caution: It is not possible to change the printer's voltage. If the rated voltage and your outlet voltage do not match, contact your dealer for assistance. [. . . ] Do not touch the green IC chip on the side of the cartridge. Doing so may prevent normal operation and printing. Do not remove the green IC chip from the side of the cartridge. If you install an ink cartridge without a chip, the printer may Do not touch this part. Align the tabs on each ink cartridge so that they rest on top of the tabs protruding from the base of the ink cartridge clamps. Do not apply excessive force to the cartridges. Make sure that the ink cartridge tabs are not under the tabs protruding from the base of the opened ink cartridge clamps. c Note: Install both ink cartridges. The printer will not work with only one cartridge. 5. Lower the ink cartridge clamps until they lock into place. Press the e ink cartridge replacement button. The printer moves the print head and begins charging the ink delivery system. When the Processing light stops flashing, print a nozzle check pattern to confirm that the head is clean and to reset the cleaning cycle. If print quality hasn't improved after repeating the nozzle checking and cleaning procedures four or five times, contact your dealer. c Connecting the Printer Your printer connects to your computer via the USB interface. Depending upon your geographic location, you may need to obtain the appropriate cable. See "Options and Consumable Products" in the Daily Use guide for details. Note: In order to connect your PC via the USB interface, your computer must be a Windows Me, Windows 98, Windows XP or Windows 2000 pre-installed model that comes with a USB port, or Windows Me upgraded from a Windows 98 pre-installed model. To connect the printer to a USB port, you will need a standard, shielded USB cable. Follow these steps: Note: For best results, you should connect the printer directly to the computer's USB port. If you must use multiple USB hubs, we recommend that you connect the printer to the first-tier hub. If your computer has more than one USB port, you may plug the cable in wherever is convenient. Make sure that both the printer and the computer are turned off. Plug the appropriate end of the cable into the USB port on the back of the printer. [. . . ] For Windows Me, 98 and 2000 users, click Start, point to Settings, then click Printers. For Windows XP users, click Start, Control Panel, Printers and Other Hardware, then Printers and Faxes. Right-click the EPSON Stylus Photo 915 icon, then click Properties. Click the Utility tab, then click EPSON Status Monitor 3. [. . . ]